Electronics Forum | Fri Nov 05 12:38:07 EST 1999 | Rich Cary
We are looking for some sealed (pressurized?) flux tanks with low qty. warning for use with our Tamura spray flux machines. I have heard that a company named "Binks" has made similar tanks for other companies, but when I search on the net for them I
Electronics Forum | Fri Nov 05 13:15:45 EST 1999 | John Thorup
Hi Rich It couldn't be simpler. www.binks.com Their main products are for paint and chemical spraying so it is likely that you will find a stock item that fulfills your need. good luck John Thorup
Electronics Forum | Fri Nov 05 21:29:56 EST 1999 | chartrain
No matter what type container you use, air in the delivery line will always be a problem. When you pop the lid on a pressurized container, fill it with a liquid and reseal it, air will be present over the liquid. Where do you think it goes?It has to
Electronics Forum | Fri Nov 05 14:00:07 EST 1999 | John Thorup
You know, Rich - if the only problem with your present method of delivery is that the container runs dry and the pump sucks air you can add a non-invasive low level alarm quite simply and for about $100. A suitable adjustable sensitivity capacitive
Electronics Forum | Thu Mar 17 03:07:17 EST 2005 | Chua
Hi, We are running lead free at wave solder now and the spray flux system is down. If we are going to able the flux manually, what problem will we be facing with the excess flux able. Appreciate for the advise.
Electronics Forum | Wed Aug 27 14:58:21 EDT 2008 | omid_juve
we have problem in setting the density of a no clean flux for using before wave soldering . first we dilute the flux but we have many short circuit problem between the pads of edge connector,then we densify the flux all the short circuit is removed b
Electronics Forum | Mon Apr 26 20:14:48 EDT 2021 | goldendragon
Hello gen, Is there any recommendation of a liquid flux for SN100 solder bar on wave? Appreciates!
Electronics Forum | Thu Aug 28 12:18:03 EDT 2008 | grics
Why yes, I regognize all the best. WML, I have an idea... I am going to call it, the Dunker. Instead of anyone foaming, I will get the wave operators to throw the boards into a rubbermaid tub full of flux/gasoline mixture and send through to the wav
Electronics Forum | Tue Sep 02 14:59:41 EDT 2008 | hermes
if two boards with different solder masks give different results on flux residue level after soldering with the exact same machine settings than it is clear that one of the solder masks is not compatible with your no-clean flux. could be the solder m
Electronics Forum | Thu Aug 28 11:31:17 EDT 2008 | patrickbruneel
Matt solder mask finishes gives the widest process window in view of potential amount of residues when using No-Clean. Shiny (glass like) finishes are more sensitive to residues due to lower surface area compared to matt finish. If the shiny finish i
winsouce.jpg)
