Electronics Forum | Fri Oct 23 09:44:43 EDT 1998 | Chrys
| We've got a continous flow cooling problem from our wave solder process into ICT. Our current configuration is a flatbelt conveyor into a manual de-pallet process, operator then places on to an edge conveyor. We've tried muffin fans, look good bu
Electronics Forum | Fri Oct 23 15:44:57 EDT 1998 | Mike
| We've got a continous flow cooling problem from our wave solder process into ICT. Our current configuration is a flatbelt conveyor into a manual de-pallet process, operator then places on to an edge conveyor. We've tried muffin fans, look good bu
Electronics Forum | Thu Mar 01 21:20:47 EST 2007 | J.R.
Let's talk pin holes and blow holes. I've been here since the transistion of leaded to lead-free process started for our company and we purchased a wave machine just to keep up with our lead-free orders. we put out 500-1000 boards a day both leaded a
Electronics Forum | Thu May 09 17:28:33 EDT 2002 | davef
There is no IPC specification, nor should there be. * There are just too many peculiarities in the design and fabrication of PWB. * The issue is not defining how to store boards. The issue setting expectation for reliable products and allowing you th
Electronics Forum | Thu Jan 14 13:25:53 EST 1999 | Chrys
| Hi Folks. Has any Process Engineer here done a complete evaluation or controlled experiment for VOC-FREE Flux? Our goal here at CEBUKid, Inc. is to implement a VOC-FREE process. We have all the necessary (OPTIFLUX) spray equipment, and we're cur
Electronics Forum | Mon Feb 22 16:39:33 EST 1999 | C.K.
| | Hi Folks. Has any Process Engineer here done a complete evaluation or controlled experiment for VOC-FREE Flux? Our goal here at CEBUKid, Inc. is to implement a VOC-FREE process. We have all the necessary (OPTIFLUX) spray equipment, and we're c
Electronics Forum | Thu Oct 18 11:59:38 EDT 2012 | jackofallmasterofnone
1) At this time we do not have a design engineer. I have contacted the PCB manufacturer about changing the drill file to close up the diameter on the holes a bit. This should allow the wings on the leads of the component to rest on top of the holes i
Electronics Forum | Tue Jun 08 17:52:53 EDT 1999 | Chrys Shea
| | | Hi,my master | | | How to iron out such soldering bridge with below conditions: | | | 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. | | | 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB | | | 3.using s
Electronics Forum | Thu Jan 14 15:10:14 EST 1999 | Earl Moon
| | Hi Folks. Has any Process Engineer here done a complete evaluation or controlled experiment for VOC-FREE Flux? Our goal here at CEBUKid, Inc. is to implement a VOC-FREE process. We have all the necessary (OPTIFLUX) spray equipment, and we're c
Electronics Forum | Mon Jan 28 08:07:44 EST 2002 | JohnW
Sorry I keep forgetting you lot are backwards in the old metric system :0) anyhoo, yes IPC, the bastions of right well as long as your board is only 1.6mm thick (sorry 62mils)say that you need 75% min general and 50% on ground planes. I'd like to se