Electronics Forum | Mon Dec 17 12:06:58 EST 2007 | pjc
5 Steps to Eliminate Bridges: 1. Establish (wave) Parallelism First and foremost, you must establish board-to-wave parallelism. This is the prerequisite to any wave solder process control. For an understanding of the power of this approach go to ht
Electronics Forum | Mon Dec 17 19:01:45 EST 2007 | bbarton
As someone with a LOT of experience with the "low cost" alternative alloys, primarily SACX, I have one simple question....Are these shorts a new phenomena? WAS your process in control, and all of a sudden it's not? If the answer is YES, take a look a
Electronics Forum | Fri Apr 21 17:34:04 EDT 2006 | kmorris
Has anyone tried this MS2 molten solder surfactant? http://pkaymetal.com/dross.php4 I'd be interested to know your thoughts/concerns. Thank you; Kelly
Electronics Forum | Mon Jun 12 22:35:57 EDT 2000 | Suan
Is there any tablets to reducce Dross Produced by the chemical reaction of the solder pot.If there is ,please recommend and to what extent is the % reduction do we expected to see. thank you Panas
Electronics Forum | Mon Jun 12 10:57:51 EDT 2000 | Jason
I am new to wave soldering. Any information is greatly welcomed. Here is the problem. After soldering the boards they have a film on the bottom of them and sometimes a white powder looking substance. I have tried decreasing the amount of flux on
Electronics Forum | Fri Jun 12 11:15:50 EDT 1998 | Ryan Jennens
Hey all! The wave solder warrior is back. I have found a flux which leave almost no residue (the least yet), but because of its super low solids content I absolutely cannot get topside fillets. The multi-layer, two sided board is on a pallet w
Electronics Forum | Thu Aug 21 14:23:56 EDT 2003 | kenBliss
In order to service your wave solder machine safely, the following needs to be understood. Ladling dross out of the machine and putting it in into a coffee can or similar is not safe and puts operators and other employees at risk. Protecting the se
Electronics Forum | Mon May 07 08:07:51 EDT 2007 | realchunks
Hi Jerry, I bet you have dross build up on your wave. Are you running nitrogen? If not this could be the case. Hope this helps!
Electronics Forum | Wed Aug 20 18:08:32 EDT 2003 | davef
We use a respirator when ever we handle dross.
Electronics Forum | Thu Aug 21 09:05:07 EDT 2003 | davef
Use a cartridge that's approved [conform to OSHA 42 CFR 84] to provide respiratory protection against organic vapors, chlorine, hydrogen chloride, sulfur dioxide, chlorine dioxide, and hydrogen fluoride with a P100 particulate filter which is effecti