Electronics Forum | Thu Apr 11 11:32:23 EDT 2002 | barryg
Hello everyone. We are interested in doing double sided surface mount. What methods are there for doing this. I know you can wave solder some smt components, but what are the limitations. Is there a method of doing this that uses 2 different solder p
Electronics Forum | Thu Nov 20 18:57:52 EST 2014 | warwolf
I can only say it looks okay for what you need, you will want a dual wave system it can make things so much easier. One thing to check would be the wave nozzle sizes I can see that the conveyor will do up to 15" but thats not to say the nozzle is
Electronics Forum | Thu Apr 11 12:10:14 EDT 2002 | jax
Different Solder types are not needed. Surface tension will hold most. Plenty of info in the archives about reflow profiles, weight limitations, etc...
Electronics Forum | Mon Jun 12 10:57:51 EDT 2000 | Jason
I am new to wave soldering. Any information is greatly welcomed. Here is the problem. After soldering the boards they have a film on the bottom of them and sometimes a white powder looking substance. I have tried decreasing the amount of flux on
Electronics Forum | Fri Jun 12 11:15:50 EDT 1998 | Ryan Jennens
Hey all! The wave solder warrior is back. I have found a flux which leave almost no residue (the least yet), but because of its super low solids content I absolutely cannot get topside fillets. The multi-layer, two sided board is on a pallet w
Electronics Forum | Mon May 14 13:56:54 EDT 2007 | jdumont
Agreed, I just bought a Electrovert Vectra Elite and have been very pleased with it thus far. I got the dual pot option for lead free changeovers and that has worked great. I can change pots in under 5 minutes, not counting the time to warm up.
Electronics Forum | Thu Aug 21 09:05:07 EDT 2003 | davef
Use a cartridge that's approved [conform to OSHA 42 CFR 84] to provide respiratory protection against organic vapors, chlorine, hydrogen chloride, sulfur dioxide, chlorine dioxide, and hydrogen fluoride with a P100 particulate filter which is effecti
Electronics Forum | Wed Jan 08 16:27:11 EST 2020 | rmitchell
We have a PCB with the dual sided connector that slides on from the edge and has leads on the top and bottom sides of the PCB. It has 20 leads on each side of the PCB with with about .8mm pitch. The PCB also has a gold grounding strip on the edge fo
Electronics Forum | Fri Jun 02 11:07:45 EDT 2017 | soldertraining
I think SEHO GoWave 1030 is better than ERSA ETS 330. The SEHO GoWave 1030 is a powerful soldering system for mass soldering applications. It's used for all types of soldering.
Electronics Forum | Tue Nov 22 10:36:23 EST 2005 | maforni
Does anyone know if there are specific tools designed to remove fingers from the wave solder rails? Thanks
