Electronics Forum | Thu Aug 19 16:28:54 EDT 2004 | davef
We don't know. "ATS Fluxer" is a SEHO product identification. So, check with your SEHO representative about the meaning of "ATS".
Electronics Forum | Wed Aug 18 08:29:29 EDT 2004 | haris
hai all, can anyone tell me what is the abbreviation for ATS in ATS spray fluxer. Mail answer to manovah@yahoo.com with best regards, Haris Manovah
Electronics Forum | Wed Nov 11 00:42:15 EST 1998 | Jason
Mike, We retrofitted all of our waves with USI spray fluxers. We are running no-clean on 4 of our waves, and OA 2331-ZX, reduced specific gravity to .825, on the other 2 With OA you must buy a special spray head to accomadate higher pressure and l
Electronics Forum | Mon Nov 16 06:54:21 EST 1998 | Michel SORGIUS
I buy 6 spray system by ERSA (http://www.ersa.de)in new solder wawe but also in retrofit. We had a very good experience whith this system. We used INTERFLUX has low residues flux. (IF2005M) This is a belgium company. Good luck Michel
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Sun Nov 08 15:27:25 EST 2015 | davef
Thinner: Flux thinner, NOT paint thinner We kept a spare stone in thinner in inventory. We cut PVC pipe to size, cap in one end, screw thread on the other, stone inside, filled with flux thinner and covered with a screw cap. I don't remember who we
Electronics Forum | Sat Nov 07 18:18:58 EST 2015 | ttheis
Hi everyone, We just got our first wave soldering machine operational (novastar 8s) and its working great. I'm just a little unsure about how to best maintain the foam fluxer daily. Do you drain it from the machine each day or just cover the flux t
Electronics Forum | Sat Oct 20 14:18:49 EDT 2012 | davef
I've been in shops with a flux containment pan under the wave fluxer. While I'd rather see excess flux in a containment pan than on the floor, but I'd prefer to see flux applied precisely to eliminate the need for either using a containment pan or cl
Electronics Forum | Wed Aug 02 12:04:42 EDT 2017 | davejohnson
Hopefully not too late of a reply... We currently have both, the Ersa ETS 330 (running LEAD solder) and Seho GoWave 1030 (RoHS solder). Bought the Ersa used, and it seems like a strong built industrial high volume machine. We've needed to modify it a
Electronics Forum | Mon May 16 18:03:30 EDT 2005 | davef
Key Issue: Will this machine solder your boards? You never know until you solder one. Any other avenues of analysis involve substantial risk. Flux Selection * High or low solids * VOC or VOC-free Solder Alloy * If using lead-free, avoid stainles
winsouce.jpg)
