Electronics Forum | Thu Nov 21 19:55:38 EST 2019 | myke03o
Would like to know what type of soldering iron you are using. On this type of big jumpers, a continuous heating soldering Iron will do the job nicely in order to heat the jumper wire properly.
Electronics Forum | Thu Nov 14 10:18:31 EST 2019 | slthomas
It doesn't look to me like the jumper wire is wetting at all. I would immediately question the solderability - do you know how that jumper wire is finished (plating type)? Also, how experienced are the solderers? It could be that the wire never get
Electronics Forum | Thu Nov 14 03:12:42 EST 2019 | jefri_simorangkir
hi Team, observed excess solder after assembly jumper with manual solder method. I already try to duplicate the phenomenon with adding more solder tin/wire,adding more time for solder but not found same condition I have attached the image for the
Electronics Forum | Fri Nov 15 11:03:48 EST 2019 | rgduval
I think Steve is on to it. The wire is not getting hot enough to wet. Either the solderer is attempting to solder too quickly, or the PTH is connected to a ground plane. The solder sticking up through the hole leads me to think it's connected to a
Electronics Forum | Mon Jun 12 10:57:51 EDT 2000 | Jason
I am new to wave soldering. Any information is greatly welcomed. Here is the problem. After soldering the boards they have a film on the bottom of them and sometimes a white powder looking substance. I have tried decreasing the amount of flux on
Electronics Forum | Fri Jun 12 11:15:50 EDT 1998 | Ryan Jennens
Hey all! The wave solder warrior is back. I have found a flux which leave almost no residue (the least yet), but because of its super low solids content I absolutely cannot get topside fillets. The multi-layer, two sided board is on a pallet w
Electronics Forum | Fri Jun 02 11:07:45 EDT 2017 | soldertraining
I think SEHO GoWave 1030 is better than ERSA ETS 330. The SEHO GoWave 1030 is a powerful soldering system for mass soldering applications. It's used for all types of soldering.
Electronics Forum | Tue Nov 22 10:36:23 EST 2005 | maforni
Does anyone know if there are specific tools designed to remove fingers from the wave solder rails? Thanks
Electronics Forum | Wed Jun 25 12:58:38 EDT 2008 | paul_bmc
How do you clean wave solder pallets of fluxes in your facility?
Electronics Forum | Wed Jun 25 13:31:57 EDT 2008 | toddl
Our wave solder pallets are cleaned via our inline board washing machine.
winsouce.jpg)