Electronics Forum | Tue Oct 11 14:02:59 EDT 2016 | mnorthey
We have a slider Bar on the back side of our Delta Wave. It is adjustable and slides up and down (adjusting bolt) on the back edge of the Lamda Wave to prevent this problem; keeping the trough behind the Lamda is essential as well. Along with attenti
Electronics Forum | Mon May 16 18:03:30 EDT 2005 | davef
Key Issue: Will this machine solder your boards? You never know until you solder one. Any other avenues of analysis involve substantial risk. Flux Selection * High or low solids * VOC or VOC-free Solder Alloy * If using lead-free, avoid stainles
Electronics Forum | Wed Aug 02 12:04:42 EDT 2017 | davejohnson
Hopefully not too late of a reply... We currently have both, the Ersa ETS 330 (running LEAD solder) and Seho GoWave 1030 (RoHS solder). Bought the Ersa used, and it seems like a strong built industrial high volume machine. We've needed to modify it a
Electronics Forum | Wed Aug 09 09:25:57 EDT 2006 | Mike F
Am I missing something here? I usually put some type of stiffener or support on the leading edge to make sure the PWB doesn't sag in the middle from the preheat. If I had to add a bean bag with shotgun pellets or BB's I would have boards falling out
Electronics Forum | Mon Jun 21 14:55:27 EDT 1999 | JohnW
| | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | for example: | | | | Solder Bridge | | 1.verify amount of flux been aplied. | | 2.verify turbulance on your solder w
Electronics Forum | Thu Jun 17 20:35:51 EDT 1999 | Earl Moon
| | | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | | | for example: | | | | | | Solder Bridge | | | 1.verify amount of flux been aplied. | | | 2.verify turbulance on
Electronics Forum | Thu Jun 17 15:18:54 EDT 1999 | Earl Moon
| Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | for example: | | Solder Bridge | 1.verify amount of flux been aplied. | 2.verify turbulance on your solder wave. | 3.etc.
Electronics Forum | Thu Jun 17 19:52:57 EDT 1999 | Tony
| | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | for example: | | | | Solder Bridge | | 1.verify amount of flux been aplied. | | 2.verify turbulance on your solder w
Electronics Forum | Mon Dec 17 15:11:35 EST 2007 | chef
Blew chunks - thanx for thinking outside the box. Of course there's two sides to every story. Just last week I had a new operator "splash" a couple of boards. Top solder was great, it was all one big solder bridge. Come to find out, the operator forg
Electronics Forum | Mon Nov 23 19:34:51 EST 1998 | Mike Demos
Charles: Here are a few possibilities you might want to check: 1) Conveyor width -- if the conveyor is too tight this will cause the boards to buckle as they go through the preheat section. We recently had this happen when we changed operators. 2
