Electronics Forum | Thu Nov 19 09:01:00 EST 1998 | Dave F
| | | | | For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wave
Electronics Forum | Thu Nov 19 08:20:04 EST 1998 | Earl Moon
| | | | For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wave so
Electronics Forum | Thu Nov 19 09:32:52 EST 1998 | Earl Moon
| | | | | | For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wav
Electronics Forum | Thu Nov 19 09:55:47 EST 1998 | Dave F
| | | | | | | For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the w
Electronics Forum | Fri Jul 28 08:08:18 EDT 2006 | Chunks
Screen printer, placement machine(s) and oven. You may also need a hand insertion line, selective solder or wave soldr and some form of electrical test. There are a ton of name brands that no two people can agree on. To get a better feel for what
Electronics Forum | Thu Jul 27 12:09:41 EDT 2000 | JohnW
Jason, where on the board is your connector?, front / back / middle? and where it on the PCB that you don't have issues with? Thief pad's are basically dummy pad's taht you have after the last set of pin's on the component are are used to draw the
Electronics Forum | Wed Jun 15 10:42:52 EDT 2005 | Steve
There used to be a product simply called bean bags that you put on a pcb to keep components from lifting up during the wavesolder process. Any one know where I might find this product?
Electronics Forum | Tue May 16 11:58:27 EDT 2006 | jsloot
What is the best or ideal cleaning method for wave solder pallets? I have been using iso prop and am not sure if this is the cause for having brittle wall material. I wouldn't think alcohol would degrade the durastone material. Most of my pallets hav
Electronics Forum | Tue Nov 17 03:04:38 EST 1998 | Charles Stringer
For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wave solder and
Electronics Forum | Thu Jul 27 08:02:55 EDT 2000 | Jason
Hello once again! I am having a problem with a 24 pin connector bridging on the wave. We use very similar connectors on other PCB with zero problems. This connector bridges in the same place on the same pins. It forms like a little block of four
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
