Electronics Forum | Fri Dec 10 08:58:19 EST 1999 | Dave F
Glen: Thanks for the clarification. I agree with Wolfgang that fluxer setup could be the source of the problem. Bottom-side wave solder shorting has a fairly wide range of potental causes. For instance slow conveyor speed can produce the same con
Electronics Forum | Mon Jun 12 07:52:21 EDT 2017 | tch
We have had this issue on our Delta 3 waves and determined that there are small pin holes in the solder pot. We had plates welded to the outside of our solder pot on the lead free wave and this bought us enough time until we could replace the wave, a
Electronics Forum | Thu Feb 23 04:04:46 EST 2006 | Rob
We used durastone, with a profile routed out to expose certain areas & protect others. Durastone costs peanuts, and the tool room uses a small cheap Micromat router.
Electronics Forum | Wed Aug 09 09:25:57 EDT 2006 | Mike F
Am I missing something here? I usually put some type of stiffener or support on the leading edge to make sure the PWB doesn't sag in the middle from the preheat. If I had to add a bean bag with shotgun pellets or BB's I would have boards falling out
Electronics Forum | Thu Jun 17 20:35:51 EDT 1999 | Earl Moon
| | | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | | | for example: | | | | | | Solder Bridge | | | 1.verify amount of flux been aplied. | | | 2.verify turbulance on
Electronics Forum | Wed Sep 01 16:31:54 EDT 2004 | alandra305
I am a used equipment dealer spealizing in cleaners and wave solder equipment. I can help you with the selection of a batch cleaner. Please contact me at 903-814-1420 Glenn
Electronics Forum | Tue Apr 05 16:20:49 EDT 2011 | cvoyles
I work with a small EMS shop that has extremely good capability because I created it for an R&D Lab for the U.S. Army. We have at times discussed leasing the equipment/facility to other companies who prefer that to farming out their work to an EMS.
Electronics Forum | Mon Jun 12 10:57:51 EDT 2000 | Jason
I am new to wave soldering. Any information is greatly welcomed. Here is the problem. After soldering the boards they have a film on the bottom of them and sometimes a white powder looking substance. I have tried decreasing the amount of flux on
Electronics Forum | Fri Jun 12 11:15:50 EDT 1998 | Ryan Jennens
Hey all! The wave solder warrior is back. I have found a flux which leave almost no residue (the least yet), but because of its super low solids content I absolutely cannot get topside fillets. The multi-layer, two sided board is on a pallet w
Electronics Forum | Mon May 07 11:09:49 EDT 2007 | davef
4 Fluxer Operation 4.1 Set-Up and Check-Out the Fluxer 4.1.1 Spray Fluxer Set-Up and Check-Out 4.1.1.1 Pass a sample unsoldered board through the machine. 4.1.1.2 Remove the board just after passing through the fluxer and the air knife. 4.1.1.3
