4877 wave solder splashes results

Electronics Forum: wave solder splashes (Page 1 of 488)

Solder splashes on gold

Electronics Forum | Tue Sep 30 14:16:49 EDT 2003 | davef

While your waiting for others to respond, search to fine SMTnet Archives on: "solder and gold and finger"

Solder splashes on gold

Electronics Forum | Mon Sep 29 23:46:51 EDT 2003 | daman

Hello everybody, We have a new product having a lot of open gold area. solder splashes during the reflow is a pain in the... Its an extremely small PCB and kapton taping is not an option. Stencil is at 10% reduction, Cleaning after every cycle. Reflo

Tinlead splashes on gold connectors

Electronics Forum | Tue Nov 30 17:32:37 EST 2004 | russ

If you are lucky, you might be able to chip the solder off the fingers with an Exacto knife and then polish it up with a pink eraser. This does work if the solder on the fingers isn't wetted very well. Russ

wave soldering and solder bridge

Electronics Forum | Mon Dec 17 15:11:35 EST 2007 | chef

Blew chunks - thanx for thinking outside the box. Of course there's two sides to every story. Just last week I had a new operator "splash" a couple of boards. Top solder was great, it was all one big solder bridge. Come to find out, the operator forg

wave solder

Electronics Forum | Mon Jun 12 10:57:51 EDT 2000 | Jason

I am new to wave soldering. Any information is greatly welcomed. Here is the problem. After soldering the boards they have a film on the bottom of them and sometimes a white powder looking substance. I have tried decreasing the amount of flux on

wave solder

Electronics Forum | Fri Jun 12 11:15:50 EDT 1998 | Ryan Jennens

Hey all! The wave solder warrior is back. I have found a flux which leave almost no residue (the least yet), but because of its super low solids content I absolutely cannot get topside fillets. The multi-layer, two sided board is on a pallet w

Selecting wave solder

Electronics Forum | Fri Jun 02 11:07:45 EDT 2017 | soldertraining

I think SEHO GoWave 1030 is better than ERSA ETS 330. The SEHO GoWave 1030 is a powerful soldering system for mass soldering applications. It's used for all types of soldering.