Electronics Forum | Fri Nov 11 04:13:23 EST 2005 | arnold
we are manufacturer of molded type transformer and we soldered are units using wave soldering machine and then we washed the units to remove flux residue. what materials or any process for us to eliminate the process of washing after wave soldering.
Electronics Forum | Tue Aug 08 20:39:29 EDT 2023 | cbeneat
What manufacturer is it? I usually stack the bars in as tight as possible. Especially against the wall of the pot with heaters. While it's heating keep applying slight pressure with a bar of appropriate material, towards the sides to facilitate melti
Electronics Forum | Mon Jan 12 02:45:53 EST 2009 | sachu_70
Hi Stefano, Although your concept of Wave soldering such devices is possible, I would look at an alternate solution. An easier way would be to Reflow solder all Bottom side SMD components with solder paste, followed by wave soldering for only through
Electronics Forum | Mon Dec 04 21:42:12 EST 2006 | KEN
Keep in mind that device pitch, pad geometry, lead length and even alloy type will play a roll in your evaluation. I have an assembly that we run 10k pieces per month. One two-pin connector has a pitch of 1.27mm. Unfortunately, the pads are 0.007"
Electronics Forum | Thu Sep 06 17:37:05 EDT 2007 | hakerem
Hi Joris - There is an excellent wave solder guide called "Take No Prisoners" that includes instructions for attacking and eliminating solder balls and preventing their recurrence: 1. Increase Dwell Time Solder balls are normally caused by too much f
Electronics Forum | Wed May 28 09:51:06 EDT 2008 | andrzej
Hi, what is minimal time for fluxer to prepare for fluxing another frame ? Is it possible to run through fluxer frame after frame without any spacing between them ? Thanks for any comments, Andrzej
Electronics Forum | Thu Apr 20 02:44:39 EDT 2017 | tsvetan
The hole is too big, you should reduce the size in the next PCB revision. The middle joint is soldered at low temperature you can see how the solder didn't distributed evently and cooled on waves. The solder joint at the bottom didn't wet the capac
Electronics Forum | Thu Jul 01 15:12:16 EDT 2010 | siddharth
Thanks to all for their inputs. @Hexielectronics, I am now trying to assemble the board by attaching it to a frame and removing the frame while waving it. I plan to put the boards back on the frame after the board cools down. Could you explain more
Electronics Forum | Thu Jun 24 15:33:56 EDT 2010 | davef
Our best suggestion - get the copper balanced and if possible go to higher Tg materials.
Electronics Forum | Fri Jun 25 15:04:39 EDT 2010 | siddharth
Thanks for you suggestions, guys. davef, I am gonna get with my PCB suppliers and talk to them about copper balancing and checking the Tg of the materials they use. SC, I am working towards designing wave pallets for my boards and try your suggesti
