Electronics Forum | Wed Sep 20 10:36:27 EDT 2006 | proy
I am considering moving my spray fluxer into a completely separate operation. Has anybody any comments of sraying VOC free flux on boards, then putting them in a drier/holding rack for possibly say overnight, then running them through wave solder?
Electronics Forum | Mon Aug 25 08:33:59 EDT 2008 | lococost
That's just dross. If you have nitrogen blowing over the wave, you could reduce its flow as it tends to blow the dust everywhere if it is set too high. (on the other hand it might reduce solder quality)
Electronics Forum | Fri Feb 21 07:14:59 EST 2020 | bk
I would always have top and bottom preheaters in a solderwave machine. Even if you can make it work without them, it's better to heat both sides of a board then just one. Far less stress on the parts you are soldering. Plus you may need it one day fo
Electronics Forum | Mon May 16 18:03:30 EDT 2005 | davef
Key Issue: Will this machine solder your boards? You never know until you solder one. Any other avenues of analysis involve substantial risk. Flux Selection * High or low solids * VOC or VOC-free Solder Alloy * If using lead-free, avoid stainles
Electronics Forum | Wed Aug 30 21:44:56 EDT 2006 | IRAS
HI, I am looking for the smallest wave soldering machine available. So far I have found some that have a total of 8 feet in length, and a foot print of 5.5 feet wide. Is there a wave solder smaller than this?
Electronics Forum | Thu Aug 31 11:34:44 EDT 2006 | flipit
Could you get by using a Wenesco or Air Vac PCBRM10 wave pot instead of an entire wave soldering machine?
Electronics Forum | Thu Aug 31 15:27:17 EDT 2006 | Chunks
We use two Streckfuss wave solder machines. They are pretty small depending on your needs. Maybe not the best, but being local and since we use a lot of their forming equipment, it works out well
Electronics Forum | Thu Aug 31 08:37:39 EDT 2006 | nodlac
um why? Technical Devices = 5'8"
Electronics Forum | Thu Aug 31 18:58:46 EDT 2006 | darby
Pleeeeeease....... tell me they only employ lysdexic slaes pensors
Electronics Forum | Thu Aug 31 22:02:57 EDT 2006 | Bubba
What the f@ck you talking about Darby? Explain yourself!