Electronics Forum | Mon Aug 25 08:33:59 EDT 2008 | lococost
That's just dross. If you have nitrogen blowing over the wave, you could reduce its flow as it tends to blow the dust everywhere if it is set too high. (on the other hand it might reduce solder quality)
Electronics Forum | Wed Jan 24 17:48:28 EST 2018 | ranap121212
Hello Could I ask for advice? We have new machines with a full nitrogen tunnel. Type of soldering nozzle: worthmann 5 rows and next nozzle (in this same machine) worthmann 7 rows. One person in my organization claims that the delta nozzle is not wor
Electronics Forum | Mon May 16 18:03:30 EDT 2005 | davef
Key Issue: Will this machine solder your boards? You never know until you solder one. Any other avenues of analysis involve substantial risk. Flux Selection * High or low solids * VOC or VOC-free Solder Alloy * If using lead-free, avoid stainles
Electronics Forum | Fri Jan 28 12:30:57 EST 2005 | glenda
We are looking for a used or new wave machine must be able to do lead free solder. Does anyone have contact information in the Chicago, il area for used wave soldering machines? Thanks for any help we can get.
Electronics Forum | Thu Oct 05 23:44:55 EDT 2006 | zoltans
Hi, Has anyone got first hand experience with the JT wave soldering machines, WS series? I use a low solid VOC free flux and it seems I have problems atomizing the flux properly and this generates soldering defects, leaving lumps and big solder bal
Electronics Forum | Sun Oct 08 23:37:37 EDT 2006 | zoltans
Hi, Has anyone got first hand experience with the JT wave soldering machines, WS series? I use a low solid VOC free flux and it seems I have problems atomizing the flux properly and this generates soldering defects, leaving lumps and big solder bal
Electronics Forum | Wed Oct 11 22:23:39 EDT 2006 | billwestiet
I've installed a number of these machines here in the US, several of them with VOC free applications. I would need to get a bunch of questions answered before I could make any suggestions: What is the pcb width? length? conveyor speed? flow rate (mm
Electronics Forum | Wed Feb 12 20:13:39 EST 2003 | cmiller
Does anyone have any experience with setting up a nitrogen supply system to a wave solder machine that is equiped for it? Does the nitrogen need to be room temp or higher? Does it make a big difference with bridging or solder quality? We bought a use
Electronics Forum | Fri Feb 21 10:31:48 EST 2003 | adlsmt
We dont have the debridging knife. I had one on an old Hollis machine I had once. It was totally worthless. I am setting up the nitrogen today. I will let you know how its goes. We are using a water based no-clean. The nitrogen will probably make a
Electronics Forum | Wed Feb 19 19:46:29 EST 2003 | adlsmt
I estimate the costs about the same but we build in batches so the wave only runs a few hours a day. We do complex boards so I think its worth it plus you have to keep the machine awhile to recoup the investment in the new nozzles. If the market gets
