Electronics Forum | Wed Jul 01 21:28:43 EDT 2020 | victorzubashev
yeap, that's probably a cheaper option. thanks for your advice!
Electronics Forum | Thu Jul 02 11:11:31 EDT 2020 | dontfeedphils
Most select solder machines I've dealt with use conductance sensors to detect solder.
Electronics Forum | Fri Jun 26 00:33:08 EDT 2020 | victorzubashev
Hello everyone, Can you please recommend a sensor to measure (contactless) level of solder inside of the wave soldering bath? ideally it should be a sensor that can reliably measure distanceto the melted solder and provide distance (as a codified si
Electronics Forum | Wed Jul 01 16:21:41 EDT 2020 | emeto
It is usually done differently. Sensor is in the solder. Once solder becomes goes below the sensor, it triggers you need to add. I believe it measures temperature rather than distance.
Electronics Forum | Sun Feb 28 20:05:54 EST 2010 | aungthura
Dear all There are alot sockets in our products,BIB.These skts are lifted abit after being solderd with wave machine.If the skts become lifted, how much tolerance of the high is acceptable? as example 1mil~5mil,or,1mil~8mil. Pls advise me. Thanks in
Electronics Forum | Wed Nov 30 15:15:34 EST 2016 | warwolf
Any lead free will eat a leaded designed wave soldering machine. But SN100c will eat it the slowest, our soldering tips used to only last 3 months with SAC305 when we changed to SN100c solder wire we are having around 9 months tip life. Our wave sol
Electronics Forum | Thu May 28 09:23:59 EDT 1998 | Chrys
| Hello, | | I need some users information about "hot air knife" after the wave | bath: | - Defects reduction ? | - In what kind of boards(TH/SMT SOICS ect.) it is applied ? | - Where can I purchase it as a retrofit (Soltec Delta 6622cc) ? |
Electronics Forum | Mon Feb 06 13:00:51 EST 2006 | amol_kane
Hi all, I just wave soldered 40 boards (20 if Imm Sn and 20 of Imm Ag) using SAC 305 (in this case the wave machine manufacturer (electrovert) suggested the alloy too). plan to carry out x-sectioning to see the results. overall, just from the visual
Electronics Forum | Tue Jun 15 12:03:27 EDT 1999 | Dave F
| Has anyone had issues where bottomside double reflowed smt has fallen off in the wave when using voc-free flux? I have verified the hotter profile was not the issue by using an alcohol based flux with no problems.This voc-free flux is also not caus
Electronics Forum | Thu Aug 31 18:58:46 EDT 2006 | darby
Pleeeeeease....... tell me they only employ lysdexic slaes pensors
