Electronics Forum | Mon Feb 23 13:27:30 EST 1998 | Doug Romm
Gary, I'm pretty much the main contact at TI for palladium lead finish questions. We have a web site at "http://www.ti.com/sc/docs/asl/palladm/index.htm" which has technical papers I have written on the subject. Also, you'll find the Pd Lead Finish
Electronics Forum | Fri Jul 09 16:50:25 EDT 1999 | Mark
There is a company named BGA Bumps that reconditions BGA IC's. Check out their web page www.bgabumps.com(below). As far as process specs you should look at the July 1999 issue of Circuits Assembly Magazine detailing many complex rework process and co
Electronics Forum | Wed Jan 07 11:18:43 EST 1998 | Richard
| Can anyone help supply information regarding where I can have a Demo SMT board manufactured with BGA,QFP,Discretes,SOIC,etc. I am looking to prepare these Demo boards with standard defects. Any suggestions out there? Another source in addition to T
Electronics Forum | Sat Jan 03 18:13:58 EST 1998 | David Jacks
Tom: You are right. Pre-heating is just as necessary in rework as it is in intiial production. Zephyrtronics produces an economical convective bottom side pre-heater known as an airbath. This product ramps the substrate and assembly at 2-4 degrees
Electronics Forum | Tue Jan 13 16:05:31 EST 1998 | Dan Lambert
CircuitCAM is less customized than CIMBridge, however it was developed with the everyday tasks of a Manufacturing Engineer in mind, thus bringing the cost way down. Its automates virtually every step of board assembly from machine programming all the
Electronics Forum | Fri Dec 26 16:28:18 EST 1997 | Jim Holst
UniCam. You go to their web site www.unicam.com | If your a CIMBridge user with HP-UX as your operating | system (like I am), I'm curious if your planning to go | to Windows_NT, as Mitron is encouraging everyone to do? | And if so, are you also get
Electronics Forum | Fri Oct 12 14:19:03 EDT 2001 | David Brink
Steve Often solder mask is the only solution but in many cases there is enought space between smt and thru-hole to utilize a component masking wave solder pallet. The advantage to a pallet is consistancy of results and excellent protection of masked
Electronics Forum | Wed Dec 05 19:15:16 EST 2001 | cnoonan
Does anyone have any information on the equipment manufacturer "My Data" I know Fuji, Siemens, Universal and some Panasonic, but �My Data� I have no clue. I am looking for people that have, worked with or on. Are they worth looking into? Looking
Electronics Forum | Thu May 02 11:34:39 EDT 2002 | Yannick
Hi, You can go to http:\\www.circuitree.com they had a supplement with the april issue of the magazine with a very good article on 4 board finish, if you are able to find it on the web site you will find all your anwser and more :)The article name
Electronics Forum | Wed May 08 11:07:54 EDT 2002 | Carol Stirling
We have a concern with moisture absorbtion/humidity effects on PWBs specifically used for automated SMT (including BGA). I'm sure there is a IPC spec on this and would appreciate the number - I've searched the IPC web-site -no results. Could you t