Electronics Forum | Mon Oct 03 05:10:19 EDT 2016 | robl
Hi Nikhilesh, It was a long time ago, but we used to buy the nickel in reels then had a cut and feed station on the smt machine with selectable sizes. We did many types of boards in very large volumes, and usually the Nickel strip was soldered to t
Electronics Forum | Tue May 17 03:48:51 EDT 2005 | Base
YV100, easy... YV112 uses a dual work-area, dual gantry machine in which the gantry does X and the PCB-table does Y movements. Also each gantry can only work on one PCB work-area and can pick form only one side of the machine. Basically you have two
Electronics Forum | Thu Apr 14 03:52:23 EDT 2016 | steve Wu
Hi,this is Steve from Chinasky Laser Technology Co.,Ltd.focusing on laser marking machine and laser welding machine.I'd like to make a discussion on laser issues with you,when it necessary.My skype:stevewu11.
Electronics Forum | Tue Nov 01 10:48:24 EST 2005 | Rob
Can't say too much about the solder joints issue, but about a decade ago we did have a lot of problems with resonators being damaged by harmonics from Ultrasonic board washing & Ultrasonic welding. However this mostly manifested itself as cracking i
Electronics Forum | Wed Sep 29 08:44:57 EDT 2004 | davef
Nothing to say that you can't purchase thermocouple wire and spot weld it in the machine shop at your local high school.
Electronics Forum | Thu Oct 26 04:36:05 EDT 2006 | aj
All, We have a Ultrasonic Welder "Sonotronic 35/1200" manufacturer M.E.E. in Johanesburg. The machine was here when I started and we use it probably once or twice a year. Basicall welds a Plastic key housing together,. I have no manuals for this m
Electronics Forum | Fri Aug 12 05:24:35 EDT 2022 | ttheis
We recently parted out a GSM machine that we could not get operational. As parts came off of the machine it looked like the frame would make the world's strongest welding/work table. We stripped the frame bare and flipped it over instead of scrapping
Electronics Forum | Fri Aug 14 07:52:03 EDT 2015 | mun4o
Hi all, 2 weeks ago we installing a new P&P machine - chip shooter.But , after installation proved that vibration of the new P&P arе very strong.If I use mashine to 100% of the speed the machine vibrating and after 2-3 panels moving 3-5 mm.The machin
Electronics Forum | Tue Sep 12 11:50:12 EDT 2023 | ttheis
I heard a similar story from a colleague on these machines. Same thing- head and beam not secured for transit and banged around whole trip. I think the beam ended up bent in that case and the machine could never be calibrated or repaired. Don't know
Electronics Forum | Tue Jun 13 13:34:10 EDT 2006 | jsmith01
Does anyone have a Manual for a Hughes/Palomar Htt-1000 power supply and a VTA-96 weld head? I acquired these machines to do a small job that we need to attach a flex cable to a thermal print head. As far as I can tell this division of Hughes was s
winsouce.jpg)
.gif)
