Electronics Forum | Fri Apr 07 17:17:55 EDT 2000 | Dave F
Ashok: You should select and use low residue tapes. But ya know, ya go out and research a great tape and if yer not careful, the buyer will second source ya and (surprise) ya got residues again. We have found that Lemme say this about Katon tape
Electronics Forum | Sat Jan 04 09:48:22 EST 2003 | Steve
Yes this is 1st generation, a large metal tube positioned horiz. with valves to wet the wiping towel all at once. We have the newer sys. on the other Ekra, motor driven gear rack and selonoid dispenser.I talked w/ their tech. and got "Oh yea,,they al
Electronics Forum | Fri Jan 03 10:55:57 EST 2003 | slthomas
I'm not sure what you mean by "standard auto valve stem". Ours use EFD pumps to dispense fluid. I think there used to be a sort of a drip system that attempted to wet the entire length of the paper all at once but have never seen one. Which system
Electronics Forum | Mon Aug 05 11:08:22 EDT 2002 | Claude_Couture
You must try cleaning the heads with a wet head cleaner. Dry tape cleaner just scratches your heads. Demagnetizer is good to use after a good cleaning.
Electronics Forum | Sat Feb 03 20:30:07 EST 2001 | Robert
James, if you want to get a circuit board wet, then any cleaner will do. Tighter componentry and BGAs are different. Even if you submerge a BGA, the surface underneath it will not be effected. Thus you need to force the chemistry mechanically unde
Electronics Forum | Wed Nov 20 12:56:58 EST 2002 | jasper
In my opinion MPM is superior as far as programming the 2D inspection. It's fast, simple and reliable. The DEK has options like Formflex. The MPM only offers adjustable vacuum box. It's difficult. 2nd hand prices are not similar. We offer used/refurb
Electronics Forum | Fri Feb 08 10:52:24 EST 2019 | roblackey
BLT 31-41 "No Clean Selective Flux For Aerospace" On a Versaflow 3/45 Atomises well, good hole penetration, good wetting, cleans off well in the solvent cleaner. Use for SN100C, SA0307, and 60/40.
Electronics Forum | Fri May 17 13:33:45 EDT 2013 | bandjwet
How are you removing the remnant cured coating materials once you scrape. laser ablate or use walnut shells to blast coating material from a PCB? We are using a soft bristled brush or a vacuum source. What about liquids such as cleaning solutions o
Electronics Forum | Thu Mar 30 12:38:14 EST 2006 | Tech
Also why I am at it. In the book CP-6 Series Maintenance Manul ( Fuji Part # MNT-C060-11.3E ) in Chapter 4 page 4-1-11 it says " The clutches should therfore be cleaned regularly, using the grease cleaner (ThreeBond 2706) provided with the machine."
Electronics Forum | Thu Nov 03 01:27:10 EST 2005 | pavel_murtishev
Good morning, Our automatic cleaner simply doesn�t clean. When I am inspecting clogged apertures I execute �cycle wiper� command few times. After wiping cycle apertures remain clogged. Zero effect. We tried to use solvent in production to improve cl
