Electronics Forum | Fri Nov 05 10:01:04 EST 1999 | Dave F
Chris: You can have more than "one question!!!" Anyhow, yes crappy solder paste can cause non-wetting, but before you go there understand why the paste is wetting some surfaces, but not others. Ta Dave F
Electronics Forum | Tue Aug 11 16:49:28 EDT 1998 | Dave F
| Looking for Suppliers of surface mount wetting balance equipment. Bucky: Section 6 of the ANSI/J-STD-002 specification lists wetting balance suppliers. Dave F
Electronics Forum | Wed Jan 04 16:43:36 EST 2006 | jdengler
Wet wipe could allow solvent through the apps and into the paste. For this reason I never never never use wet wipe.
Electronics Forum | Tue May 23 09:01:48 EDT 2006 | russ
Seems as though the problem is with PCB and not component? "Solder does not wet to pads, wets to component" What is your board finish? Russ
Electronics Forum | Mon Oct 22 20:41:32 EDT 2007 | jkhiew
Hi Dave, The solder has tended to wet the component termination of Ag/Pd (chip capacitor) but has not wetted the pads, whereas the solder has wetted both termination & pads when using Ag/Ni/Sn finishes. Thks
Electronics Forum | Mon Nov 12 01:18:29 EST 2007 | sin4d
Hi, ALL I experience some QFP with wetting issue on the heel of the lead. There is no fillet wetting on the heel which causes reject bt the customer, but not all the QFP. Could anyone pls help what is the causes of this problem, it is due to oxidati
Electronics Forum | Fri Mar 23 03:41:19 EDT 2012 | grahamcooper22
try Almit Sn62 HM1 RMA V14L ....its the best no clean lead paste for wetting...I sell it and it has solved wetting problems many times when users have used other pastes
Electronics Forum | Fri Oct 21 12:22:56 EDT 2016 | horchak
Looking at your picture I'm not sure you have a wetting problem. Who determined it's not wetted? Are you having functional failures? Is this an isolated incident? What was your TAL? Is the pad on the suspect ball possibly smaller than the others, or
Electronics Forum | Fri Feb 24 19:22:58 EST 2023 | SMTA-71549289
From my understanding titanium is typically used for non-wetting nozzles, correct? And then wetting nozzles are made of other metals with a coating that allows it to wet.
Electronics Forum | Mon Jul 31 03:50:26 EDT 2023 | calebcsmt
Is below the correct interpretation of IPC 610/JSTD requirements for FLAT LUG LEADS (seen on USBs and Diodes mainly) For class 1 or 2, no toe wetting would be required as minimum side joint is only 'evident wetting' and no actual length or fillet he
