Electronics Forum | Mon May 30 09:11:15 EDT 2011 | davef
3a ANSI/J-STD-001: * Temperature and Humidity: 18-30°C, 30-70%RH ** If out of range, shall verify electrostatic discharge control program according to ANSI/ESD S20-20 is adequate. ** For process control, more restrictive temperature and humidity lim
Electronics Forum | Tue Mar 12 16:01:32 EDT 2024 | SMTA-64387182
What is the best IPC standard to refer to for Cleaning of Printed Board Assemblies? Thanks, Joe
Electronics Forum | Sun Feb 16 05:57:02 EST 2014 | alexeis
Hi, From our experience, Gerber files are accompanied by IPC type files. These files usually have extensions: IPC, NET, 356. We have developed products that are designed to help in programming part of the SMT machine, based on these files beyond sta
Electronics Forum | Sat Oct 21 21:39:43 EDT 2006 | Mats
"Surface Mount Techniques has approximately 98 percent of the world market share of large Panel Stencil Printers". It sounds a little bit strange to me, especially since I work for one of the companys listed in their advertisement and it is definite
Electronics Forum | Wed Mar 27 16:32:22 EDT 2024 | SMTA-64387182
Thanks all, That is very helpful. Joe
Electronics Forum | Mon Oct 23 12:58:28 EDT 2006 | grizzy
"Surface Mount Techniques has approximately 98 > percent of the world market share of large Panel > Stencil Printers". > > It sounds a little bit > strange to me, especially since I work for one of > the companys listed in their advertisement an
Electronics Forum | Thu Mar 14 15:55:34 EDT 2024 | davef
Process Requirement Standard - J-STD-001 - Requirements for soldered electrical and electronic assemblies depicting minimum end product acceptable characteristics as well as methods for evaluation (test methods), frequency of testing and applicable a
Electronics Forum | Wed Mar 13 13:08:31 EDT 2024 | lambert
Section 8 in the J-STD-001 was the initial place to start with cleaning and the requirements, however with all the changes going on within the industry with increase product densities and such, a revision is being created to help understand the need
Electronics Forum | Fri Apr 16 17:19:59 EDT 1999 | Dave F
| | Hi, | | I just cheesed my previous attempt at this. I looked through IPC 600 and couldn't find anything relating to dimensional stability of a board with regard to stretch. I found bow and twist but nothing on size. I have a PCB that is .030"
Electronics Forum | Mon Apr 19 10:14:12 EDT 1999 | Justin Medernach
| | | Hi, | | | I just cheesed my previous attempt at this. I looked through IPC 600 and couldn't find anything relating to dimensional stability of a board with regard to stretch. I found bow and twist but nothing on size. I have a PCB that is .0
