Electronics Forum | Wed May 06 20:52:26 EDT 2015 | arbpkevin
I have been using my topaz X for about 4 years now and I feel that I am fairly knowledgeable about it, at least the functions of it that I use... I am trying to use the LCS to place some qfp chips on a new product and I have set the whole thing up t
Electronics Forum | Fri Apr 08 21:39:17 EDT 2011 | jimlas53
Hi, We have a Quad IVc set up with all picks, placements, and sequence working. I have managed to get through several passes with some pain, mainly from SOT-23 parts, but it is getting better. On occasion, when picking from one of three feeders loc
Electronics Forum | Sat Dec 01 18:08:03 EST 2007 | jmelson
Hello, I just ran into a crazy problem with my CSM84. I did a batch of one side of a board, then loaded the program to do the top side, and it stops with the head over the 3rd component's feeder, and reports error 117:overflow. The maintenance manua
Electronics Forum | Fri Feb 03 10:34:09 EST 2017 | prdmm1
PANASONIC ERJ-12ZYJ203U i am having a lot of problems picking this resistor up. i have purchased a new tool per engineering (NOT the problem). it seems the my9 is picking up then dropping it. then the machine goes to pick another and picks the dropp
Electronics Forum | Wed Nov 14 16:03:08 EST 2018 | cbeneat
Wondering if anyone will have an idea on what we are experiencing with our Panasonic. When the machine goes to change nozzles,it errors out saying "Nozzle exist error(Rack) occurred,(R side)" There is nothing in the nozzle bank, actually replaced ban
Electronics Forum | Fri Sep 20 16:25:47 EDT 2002 | bdoyle
ok time for a "what if" What if someone came back a year after a question was posted. The question dealt with a problem that this person had but didn't exactly cover everything. Would it be better for this person to post a new thread (and then mig
Electronics Forum | Fri Dec 17 18:21:43 EST 1999 | Clarissa L. Ortner
We are a small start up. We will be buying a stenciling machine and semi automated pick and place. ( We have the oven) We are presently stenciling without any assit and loading leadless parts only(no fine pitch) by hand. We need to improve thrupu
Electronics Forum | Fri Jan 12 08:41:12 EST 2007 | geb
Hi, Our GSM1 pick and place machine has an Axis head 2 Z velocity error. None of the spindles of Head 2 work during placement and it brings up the error message. It will not proceed after that. I have tried lowering and raising the spindles in the
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Mon Sep 13 20:30:43 EDT 2021 | jamesatqkits
Hello all, thank you to the people that have been helping me out, Hristo and Bukas. I just thought I should put this out there and see if any one can help. When I try to pick up a nozzle I get the following error: [0800] <EMER&gt
winsouce.jpg)
