Electronics Forum | Wed Jun 12 08:33:39 EDT 2013 | emeto
Just measure width, length and thickness and buy from anyone that sells belts. This is just the website that comes on the top when I typed "conveyor belts" in google http://www.beltcorp.com/profile.html
Electronics Forum | Wed Jun 12 14:36:15 EDT 2013 | rollon65
Hi Bert I had belts made for my conveyors using Habasit material made by Benson's belting here in U.K. They have been running now for 6 years or so and I am very satisfied with them. We are 12K miles away but check out their website at http://www.
Electronics Forum | Thu Jun 13 08:53:25 EDT 2013 | markhoch
Ahhh yes. The infamous round rubber belts used on the Fuji CP2's and CP3's. :) I remember fondly using a pair of dykes and a Bic Lighter to make my belt repairs. Does anyone know if these are still available from Fuji? You may be able to find repl
Electronics Forum | Wed May 22 19:41:11 EDT 2013 | bvdb
We're located in New Zealand running an older Fuji pick-and-place machine that uses long rubber conveyers about 1/8" diameter and 8 feet long to move the PCB through the machine. The ones on our machine are old and keep breaking. We've been repair
Electronics Forum | Mon Jun 20 23:17:49 EDT 2011 | lisalau
OMG,it's terrible!! I will go to Germany to purchase machines next month,they are supposed to be workable;and i will not pay for the money until i see the machine's working condition,and will stay there until the machine is shipped as well..I bet thi
Electronics Forum | Fri Aug 27 11:27:55 EDT 1999 | Brian
I have looked through the IPC web page and surfed to frustration. Can somebody give me a lead?
Electronics Forum | Sat Aug 28 09:23:36 EDT 1999 | Mike McMonagle
| I have looked through the IPC web page and surfed to frustration. Can somebody give me a lead? | Check out the EasyBraid website below, they carry IPC standard coupons, flux test kits and SIR meters at reasonable prices.
Electronics Forum | Mon Aug 30 16:10:10 EDT 1999 | Dave F
| I have looked through the IPC web page and surfed to frustration. Can somebody give me a lead? | Brian: We don't use an etched board. We use a special stencil, described below and print on bare copper laminate. 3 Solder Wetting Test. Recogniz
Electronics Forum | Fri Feb 01 02:32:31 EST 2019 | robl
It's nice to be able to do things in house, and it's good to have somewhere without commercial pressures to learn and make mistakes, so I can understand where you are trying to go. Those machines look a little lightweight for consistent quality pr
Electronics Forum | Wed Dec 06 11:16:06 EST 2006 | Todd
Ok, an update... I finally found my 24Vdc. I was trying to use a screw and/or outside of the connector for ground. It was necessary to use the ground IN the connector pins. I believe it was the top/right and 3 o'clock pins that toggled with the 24Vdc
.png)
