Electronics Forum | Tue Dec 05 15:40:05 EST 2006 | jdengler
What year is your machine and what year is your Electric Drawing? My machine is 1989 and so is my drawing. I do not have a SIP-1750 drawing. The IP went through several changes during its production so your machine may not match mine. The CON I/F
Electronics Forum | Wed Dec 06 11:00:30 EST 2006 | jdengler
All of the IP-1's I have seen use a fixed feeder bank. No MFU's which is where the board is located for IP-II's. Jerry
Electronics Forum | Mon Dec 04 14:13:50 EST 2006 | Engguy
What is the part# of the card you seek?
Electronics Forum | Tue Dec 05 14:23:55 EST 2006 | Todd
I'm not finding 24Vdc at any feeder location?! I checked all pins with the coresponding feeder activated through the I/O and a key in the emergency disconnect. Am I not using the correct procedure to check for my 24V?
Electronics Forum | Wed Dec 06 10:02:19 EST 2006 | cyber_wolf
Do IP1's use MFU's like the IP2's ? If so I can most likely tell you what the problem is.... Please advise.
Electronics Forum | Wed Sep 10 15:37:09 EDT 2008 | djmic
I just purchased a soldering station and it came with the silicone grease for the desoldering gun and say's for cleaning spring filter and filter pipe, now do I just smooth this grease all over the spring and tube the spring goes in?
Electronics Forum | Fri Sep 12 08:22:31 EDT 2008 | davef
Your supplier is probably the best source of advice on this issue. Some offer tips like: http://www.n0ss.net/hakko_808_notes.pdf Depending on the design, some use grease to reduce air leakage on: * Filter tubes * Gaskets or O-rings * Threads We ha
Electronics Forum | Mon Dec 04 13:06:09 EST 2006 | Todd
I work for a small SMT contract manufacturer with a couple SMT lines utilizing both old (IP1, CP3) and newer (CP643, XP242)Fuji machines. We have an issue with an IP1 that has us stumped. One of the device locations has no power. After some basic tro
Electronics Forum | Mon Dec 04 14:21:49 EST 2006 | jdengler
Todd, It's been a while since I have looked at this but I believe the IP-1 does not have a relay board for the feeders. +24 Vdc is wired to a pin on the connector and the I/O board (NO 3 I think) switches the ground. If you don't have +24 Vdc at 1
Electronics Forum | Tue Dec 05 13:59:40 EST 2006 | Todd
The "Relay PCB" is # CON I/F 8909-0. Of course it's a real old drawing with many of the P/Ns being obsolete. I'm looking at drawing # SIP-1750. The Relay PCB is shown between the 1st station connectors and the control box. In the meantime, I'll doubl
