Electronics Forum | Mon Feb 27 19:48:32 EST 2006 | stepheniii
I'm not sure that would be valid. My understanding was that solids were trapped by other non-active flux residue. Which is why you can leave them on and why you see white residue after washing. I think the ROSE test would release particles that woul
Electronics Forum | Sun Feb 26 17:40:35 EST 2006 | GS
Hi, just my comment, theoretically No Clean means no Ion Contaminants from Flux, but it some some case ion contamination (Cl-Br-F) could come out from raw PCBs, from Components, from fingerprints, etc. To incorporate a ROSE step in the pro
Electronics Forum | Sun Feb 26 21:48:28 EST 2006 | Mike Konrad
Hi GS, Just a clarification� No-clean does NOT equal no ions. It equals less ions (at best). Automatic R.O.S.E (Resistivity Of Solvent Extract) testers are commonly used to detect ionic contamination from no-clean applications. Your comment rega
Electronics Forum | Tue Feb 28 14:32:26 EST 2006 | masrimhd
As I know, the encapsulation effect occurs only with rosin based fluxes. So if you have a PBA soldered using RA Flux, you should either wash it well, or leave it alone and it will be safe. For NC process the story is different because there�s no re
Electronics Forum | Fri May 14 15:03:19 EDT 1999 | lima
| | Does anyone know of any industry guidelines for the exhausting of volatiles in reflow ovens? I've seen some numbers like 1,000ppm for the oven atmosphere, but is this typical? | | | | My concern is the volatiles in my WS629 solder paste may be
Electronics Forum | Wed Jun 14 05:05:27 EDT 2006 | bk
Yes it's definately possible to have too much flux. You'll see a white residue film on the board. In the past we have had hipot issues cause of too much flux residue ,left on the boards. You defininately don't want to be using a no clean flux and sti
Electronics Forum | Thu Jul 15 18:50:43 EDT 1999 | Raeto Zryd
We intend to use VOC free fluxe in our nytro machine. Does anybody know if there can be problems with water ie. solvent residues in the tunnel. Perhaps there are some white papers available on that issue.
Electronics Forum | Wed May 16 12:11:03 EDT 2007 | slthomas
Is the frame turning white or is it the flux residue? What kind of flux, WS or NC?
Electronics Forum | Mon Apr 29 10:42:47 EDT 2002 | Jim M.
I had problems with white residues on both WS609 and WS 3060.The WS 3060 turned out to be a carbonized material.The composition after analysis (Energy Dispersive X-ray spectrum) turned out to be tin,tin,phosphore and cloline and tin. Alpha also have
Electronics Forum | Fri Jul 16 22:49:55 EDT 1999 | Vic Lau
| We intend to use VOC free fluxe in our nytro machine. Does anybody know if there can be problems with water ie. solvent residues in the tunnel. Perhaps there are some white papers available on that issue. | | | | | Dear Raeto, In my experienc
