Electronics Forum | Tue Jul 02 12:33:32 EDT 2002 | Mike Konrad
We have had success removing white residue. A change of chemical (PCB-Wash or Vigon A200) have a good track record in removing white residue. As Dave stated, we (and others) operate a contract cleaning service. Contact me offline and I�ll provide
Electronics Forum | Fri Apr 03 08:22:36 EST 1998 | Scott Cook
| At this moment in time we are using water soluble solder paste on our PCBs these are cleaned using water only, agitated with ultrasonics. After drying a white/grey residue is left around solder joints. Reflow profile is fine and a reliable wash pro
Electronics Forum | Wed Oct 11 09:55:10 EDT 2000 | Ian Harrison
Some boards that are populated by one of our subcontractors are getting a white powdery residue forming on them. I think it is the non clean flux and process which they are using that is causing the problem. Their process is as follows. Flux is put i
Electronics Forum | Thu Oct 12 17:56:58 EDT 2000 | DennisF
The white residue can be caused by putting Alcohol on the no clean product. Some people will attempt to clean an area they have reworked.
Electronics Forum | Fri Oct 13 15:16:43 EDT 2000 | Dave F
George and the others make good points. Check Les Hymes response to a similar question in 7/00 "Circuits Assembly"
Electronics Forum | Wed Oct 11 10:29:28 EDT 2000 | G. English
Try the following steps : FIRST CHECK THE ARCHIVE for further information, it WILL help you. Step One : What�s the chemical analysis of this white res? Obtain a sample. It could be tin, rosin, or something else??? Step Two : The fastest way I know
Electronics Forum | Fri Oct 13 05:21:08 EDT 2000 | Robert Steltman
Looking at the original post, it seems that the white residue is formed on the board after wave soldering and becomes evident when it has been left standing for a while. From what I understand, it seems that the solids content of the "no clean" flux
Electronics Forum | Thu Feb 04 12:01:07 EST 2016 | g2garyg2
Hi Luis A white mask typically helps in the marking process since you are not reliant upon the PCB layers to create the contrast. Laser marking is really an etching process, so if your laser is set properly (power and focus) the goal with mask is to
Electronics Forum | Sun Aug 29 19:17:34 EDT 2004 | aqueous
Chen, It is always best to place one�s effort on determining the cause and content of the residue rather than trying to work around it. The first thing you must determine is the nature of the residue. Is it flux? In many instances, the residue is
Electronics Forum | Fri Aug 28 05:07:59 EDT 2009 | sachu_70
Do you clean the stencil manually or using the automated under-stencil cleaner on your Printer (recommended)? 1. Ensure that stencil wipes are lint-free and soaked sufficiently with solvent before use. 2. If your printer supports automated cleaning
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
