Electronics Forum | Tue Jul 06 18:16:14 EDT 1999 | Boca
| | Is anyone aware of some guidelines regarding through-hole in SMT pads? One of our designers wants to add through-hole leads in some SMT pads for an inductor. The size of the hole is 0.032 inches and takes-up approximately 25% of the pad area.
Electronics Forum | Tue Jul 06 17:03:46 EDT 1999 | Earl Moon
| Is anyone aware of some guidelines regarding through-hole in SMT pads? One of our designers wants to add through-hole leads in some SMT pads for an inductor. The size of the hole is 0.032 inches and takes-up approximately 25% of the pad area. Th
Electronics Forum | Wed Feb 05 19:43:34 EST 2003 | iman
If by the Powers Ta Be (customer/designer), you can't change the PCB design, negotiate for the PCB fab house, to block the via holes with their (green?) solder mask some customers/designers want to have via holes to be present in the PCB pad, due to
Electronics Forum | Thu Feb 06 14:47:50 EST 2003 | MA/NY DDave
Hi "some customers/designers want to have via holes to be present in the PCB pad, due to some belief that it helps in heat dissipation. " As I think about this I don't know exactly why they would be concerned. I can imagine in some exotic products
Electronics Forum | Wed Feb 05 21:05:38 EST 2003 | davef
Iman On your situation: As an earlier poster stated, your options are limited to opening you stencil aperture to compensate for the paste lost to the via. On your designer's belief that "it helps in heat dissipation": Could be true, but: * Hole wil
Electronics Forum | Fri May 28 17:30:35 EDT 1999 | Dave Clements
I discovered that we have some gold plated (30 mico in.) through hole connectors which were Paste In Hole soldered (60 sec at reflow) on a HASL PCB. Do we have an embrittlement reliability issue? The calculated volume % of gold in the joints is about
Electronics Forum | Fri May 28 17:44:51 EDT 1999 | Glenn Robertson
| I discovered that we have some gold plated (30 mico in.) through hole connectors which were Paste In Hole soldered (60 sec at reflow) on a HASL PCB. Do we have an embrittlement reliability issue? The calculated volume % of gold in the joints is abo
Electronics Forum | Thu Sep 04 10:03:13 EDT 2003 | Rick B.
I'm attempting to develop paste in hole process so that I can reflow a few plated through hole components on a mixed tech board. Tried various pastes, profiles and stencil thicknesses. Would appreciate any insights and/or pointers anyone can share on
Electronics Forum | Tue Jun 04 13:13:58 EDT 2002 | slthomas
Another thing we see is solder balls (sometimes fines, sometimes larger stuff) in the vias after a misprint has been poorly cleaned, as in wiped down but not washed. They end up in the plated through holes too, but those get nicely cleaned up in the
Electronics Forum | Wed Apr 16 13:19:13 EDT 2003 | Takfire
Thanks Russ! The origianal complaint from the customer was in regards to what appeared as "bumpy" appearance and "holes" in the solder fillet. This problem was originally presented as an appearance issue only. Further investigation by our DPA lab r
