Electronics Forum | Wed Jan 15 12:10:22 EST 2020 | emeto
Avillaro, I don't have hands on experience with Vapor Phase equipment, but my guess is that it will work better for thick boards like yours. Trying another chemistry is a logical move. May be it is worth trying the fixture for connector flatness as n
Electronics Forum | Wed Jan 15 10:31:55 EST 2020 | emeto
Having 10c thermal differential is a lot. Trying different paste might help - usually thermal expansion makes component detach from PCB, then joint is formed and solidified, then component goes back but is too late to form a joint. Cooling speed migh
Electronics Forum | Wed Jan 15 11:53:40 EST 2020 | avillaro2020
As far as the large thermal gradient I have on my thick and thermal heavy board, I've done quite a bit to minimize the gradient but not successful. it's like one pad is connected to a signal while the other pad is connected to ground, you can't bring
Electronics Forum | Tue Jan 14 11:53:44 EST 2020 | avillaro2020
Hi Phil, thanks. I am successful using the same connector on small thinner boards 2-2.5kg) i cant make it work, tried all kinds of profiles with vapour phase but to no avail. Yes you read it right 4.3-6.3mm pcb thickness and 2-2.5Kg. And it is 44 lay
Electronics Forum | Mon Jan 13 17:39:49 EST 2020 | avillaro2020
Hi, I need help on how to address the solder wicking on the samtec searay connector after reflow resulting to open solder joints on thick and thermal heavy PCB (4.4mm and 6.3mm). I increased my solder paste thickness to 8 mils, the connector is manua
Electronics Forum | Wed Nov 07 11:56:44 EST 2001 | mparker
Pad spacing is just one element to consider. Your pad spacing is determined by the pitch (center to center distance between the leads). There are several good resources to find the appropriate pitch per device. Search the archives here or refer to th
Electronics Forum | Thu Jul 02 16:01:57 EDT 2009 | ewchong
thanks kpm. agree the cause of those pads lifting. all of them were no connects so they cannot be the cause of the electrical failure. when the bga was removed, all the solder balls on the pcb turned into conical shape due to the separation, except
Electronics Forum | Thu Oct 31 09:34:38 EST 2002 | russ
We do this all of the time, This is what we do but I would be interested in other methods. 1. Remove component with BGA type rework station 2. Wick off lead pads only, verify/create even solder surface on the thermal pad on the board 3. Apply no-cle
Electronics Forum | Mon Jul 31 10:51:11 EDT 2006 | Chunks
OK so you're stuck with gold. Not all that bad unless you're paying for it. Gold is very flat compared to HASL, so you should have no problems printing. This should lead to good placement as well. But after oven you mat have a big contrast betwee
Electronics Forum | Wed Nov 21 10:41:03 EST 2001 | arzu
Hello, Sometimes you have no choice other than putting uvias in ubga's-pads. I know examples of high-end mass production of products with ubgas having voids. (no problems, but always voids visable in x-ray) I also performed a DOE a while ago to avoid
