Electronics Forum | Wed Nov 18 14:42:22 EST 1998 | Dave F
| I heard somewhere that SMEMA has joined IPC, and that the association has decided to boycott Nepcon from | year 2000. Can anyone tell me if this is true | Nick: SMEMA and IPC are talking about merging (EP&P, 11/98, p 18). Below is a news release
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Wed Apr 21 14:32:52 EDT 2010 | remullis
These ovens maintain good profiling as long as you stay on top of maintenance. I had 4 150's and 1 125. The biggest headache is keep the plenums cleaned (very messy). Also the blower motors have been replaced a few times on them as well. If I were yo
Electronics Forum | Sun Dec 19 17:45:35 EST 1999 | Bill Petlock
Clarissa, Buying used equipment should not be risky if you do your homework. As M COX said, you should find out if the manufacturer still supports the machinery but don't take everything they tell you as gospel. Remember, they want to sell you a new
Electronics Forum | Wed Sep 23 08:19:52 EDT 2009 | rgduval
Check to see if there's a loose cable, or something, that's randomly setting off the light curtain. We occasionally have that problem with some of our flex or 12/16 mags in our TP9, where the tape take up clip is loose (nothing in that feeder) and i
Electronics Forum | Mon Jul 17 05:03:07 EDT 2017 | svfeingold
Hi, I am evaluating equipment for a new SMT line that I will run myself as a side business. I have so far settled on Assembleon as the machines are available and I have heard good things about them. Your comment gives me pause. Is it really such a b
Electronics Forum | Tue May 28 18:57:40 EDT 2024 | lambert
The scoring or grooving creation is found in IPC-2222 and describes the standard scoring parameters, with an illustration of the critical parameters. There are many articles on the web describing the process. Many of the articles promote a groove dep
Electronics Forum | Fri Jul 21 12:34:31 EDT 2017 | svfeingold
Hi Sumote, thank you for the advice! I actually visited the K&S service center, they are the company that now handles the Assembleon line. They have service/training techs there who have been around since it was part of Philips and are very familiar
Electronics Forum | Mon Jul 13 06:30:59 EDT 2009 | hcarrasco
1.- Check your vacuum a.- Check filters b.- Check air flow (the vacuum is generated by a Ventury using air flow, not air pressure) c.- Vaccum vias (Possible linth inside the vacuum lines) 2.- Check the nozzle condition (Probably broken o
Electronics Forum | Mon Jul 17 15:35:09 EDT 2017 | svfeingold
Evtimov, I thank you for your response. I posted a thread about this on EEVBlog but there is less experience there for this type of equipment it would seem. If your interested there's a lot more detail about what I'm after: http://www.eevblog.com/for
