Electronics Forum | Wed Feb 16 17:28:14 EST 2005 | davef
Greg: As we understand it, in your situation: * One 0805 lead solders to board properly * Another 0805 lead does not solder On the 0805 lead does not solder, there does the solder go? * On the pad * On the component lead A common solderability test
Electronics Forum | Tue May 13 07:04:54 EDT 2014 | hemant_pang23
I am looking for the solder wire leaded or lead free which can withstand the solder joint at temperature 450deree Celsius or more after soldering, since i need to form a solder joint at higher temperature area Pls suggest the part number for the sam
Electronics Forum | Thu Dec 21 21:37:19 EST 2006 | Jack
Hi Pavel, Real Chunks, Thanks for your valuable inputs..Selecting the correct location for board profiling is critical in determining the solder joint quality. Am I right to say TC wire attachment locations priority should be as below: (1) Thermal
Electronics Forum | Wed Dec 20 23:29:32 EST 2006 | Jack
Hi all, Is there anyone know the correct way to obtain the accurate temperature profiling for oven reflow? Are below claims true? (1) Instead of full components on the PCBA (Motherboard), the profile taken from PCBA with few components can be cons
Electronics Forum | Thu Dec 21 02:27:57 EST 2006 | pavel_murtishev
Good morning, (1) This depends on component type. In general it would be better to have fully populated board. Or at least you should mount components with different thermal mass. You should place TC�s at three points at least: component with high t
Electronics Forum | Thu Dec 21 10:27:24 EST 2006 | realchunks
>>> Now you must take into account your total board mass as well. If you have tons of heat sinks, or parts on the other side that can affect your profile, you should have them on the board when profiling. That�s where the "engineering" part in all
Electronics Forum | Fri Apr 13 21:02:19 EDT 2007 | Sam
Anyone experience using SnPb wire to gold plated ICs? I have tried to solder the SnPb wire to the gold plated ICs lead, but the surface finishing is dull. Can anyone explain that to me? Why it is not shinny surface? Any recommendation?
Electronics Forum | Thu Oct 05 07:23:34 EDT 2006 | Chris
Hi all experts, I have no background about PCB or SMT process. I am now encountering some issues after SMT - Unstable stitch bonding condition. I am now suspecting some contaminants remain on lead after cleaning. Therefore, how can I check th
Electronics Forum | Sun Apr 15 23:35:14 EDT 2007 | Sam
few more questions: Is there any standard saying that the dull surface is accepted if solder Au plated leads? Understand that more than 3% Au in the solder connection leads to unacceptable embrittlement of the connection. How about any standard relat
Electronics Forum | Mon Apr 16 09:12:23 EDT 2007 | davef
Standard for appearance: J-STD-001 and IPC-A-610 committees eliminated the requirement that solder connections be "bright and shiny". Certain solderability protections; such as Au, NiPd, NiPdAu; can affect the surface texture of a solder connection,
