Electronics Forum | Thu Mar 08 07:27:07 EST 2007 | davef
What are you cutting at incoming? Meat? It doesn't matter that your troop are using ESD mats and wrist straps. Your proposed cutting board is an insulator. It a BIG piece of plastic. So, it will retain a charge. So when you move to adopting ANSI
Electronics Forum | Fri May 23 23:47:46 EDT 2008 | dint46
Wayne; Several things. 1.check the vendors and see what black oxide they are using are they the same ? It might be that. 2.You should bake your pcbs before the thermal stress is applied. To remove moisture. At your shop. The proce
Electronics Forum | Mon Jun 01 11:38:28 EDT 2009 | operator
So would the proper technique be as follows: 1. Grounded operator picks up PCB from ESD rack and attaches a 1meg(wrist strap cord)shunt to ground to a grounding surface on the pcb. 2. operator sprays conformal coating onto pcb using a spr
Electronics Forum | Wed Jul 08 06:02:59 EDT 2009 | stepheniii
Advertisements are not always 100% accurate on technical issues. You don't want instand static discharge. A wrist strap with no resistor could cause that. Therefore put in a current limiting resistor to make the charge dissipate slowly. Does anyone
Electronics Forum | Wed Jan 22 14:25:17 EST 2014 | rgduval
In the purest sense of ESD control, we would have to say yes, use ESD tape to cover the gold fingers. The gold fingers are connected directly to input/output controls for the card, and, as we all know, when handling boards, we're supposed to avoid c
Electronics Forum | Wed Jun 02 13:13:41 EDT 1999 | Tim
ok, ok, so I'm not an engineer. I'm a salesguy ( and that's nothing to be ashamed of...) Here's my dilemma. I represent a contract manufacturer who is in the early stages of quoting on "turnkey" assembling of a circuit board for a manufacturer of
Electronics Forum | Wed Jul 10 18:05:11 EDT 2002 | mikestringer
What have your experiences been with static meters for maintaining your ESD program? As part of our ESD program I am after an improved method of identifying risk items, or items not performing to specification. We use wrist and foot straps, ESD flo
Electronics Forum | Wed Jun 02 13:27:05 EDT 1999 | Earl Moon
| ok, ok, so I'm not an engineer. I'm a salesguy ( and that's nothing to be ashamed of...) Here's my dilemma. I represent a contract manufacturer who is in the early stages of quoting on "turnkey" assembling of a circuit board for a manufacturer
Electronics Forum | Fri Jun 04 06:54:10 EDT 1999 | S. Kopetzky
| | ok, ok, so I'm not an engineer. I'm a salesguy ( and that's nothing to be ashamed of...) Here's my dilemma. I represent a contract manufacturer who is in the early stages of quoting on "turnkey" assembling of a circuit board for a manufacture
Electronics Forum | Wed Jun 02 15:11:56 EDT 1999 | MD Cox
| | ok, ok, so I'm not an engineer. I'm a salesguy ( and that's nothing to be ashamed of...) Here's my dilemma. I represent a contract manufacturer who is in the early stages of quoting on "turnkey" assembling of a circuit board for a manufacture
winsouce.jpg)
