Electronics Forum | Wed May 15 22:23:38 EDT 2002 | ianchan
Hi mates, need some help to resolve a thumb-twine situation. As a high-mix, low volume prototype build house, we always conduct a first article inspection (FAI) on every model setup conversion in the SMT production Lot run. we do this FAI by mounti
Electronics Forum | Mon Sep 08 11:38:52 EDT 2014 | spoiltforchoice
They key requirement before any fancy tools is careful storage, stock control, labeling and handling. If your parts are incorrect before they even get to production, you're screwed. As gregp suggests, to get consistently correct value and orientation
Electronics Forum | Thu May 28 21:13:09 EDT 1998 | skhun
| Our company is currently looking to implement a SMT production line. What I am looking for is feedback on people's experiences with various machines. | Here's what we are in the market for: | Low/Mid volume 3,000+cph machine that can handle high j
Electronics Forum | Mon Sep 17 06:11:41 EDT 2012 | kq702
Hi I did a reflow on a laptop board and after the reflow the board is warped in the area I did the reflow in, and now the laptop screen does not turn on at all when I put it back into the laptop. Original problem was the wifi (I did the reflow more o
Electronics Forum | Thu May 03 22:51:14 EDT 2007 | jmelson
I am still learning the CSM84, but have gotten one board programmed and working. Now, I'm doing the next board, and need to use the mechanical alignment unit for a 22 x 22 mm TQFP. This chip is too large to clear the jaws on any head. Can the CSM h
Electronics Forum | Fri Oct 16 00:23:16 EDT 1998 | Jim McCarten
I do not think that the Mydata can pick from wafer or has the accuracy required (12 micron)! Am I missing something? | | I need to install some new lines for high mix low volume products in an already cramp building. Could someone share any info a
Electronics Forum | Thu Dec 14 04:02:40 EST 2017 | spoiltforchoice
"I would expect that any intelligent feeder > enabled machine would pull the correct part no > matter where it is placed on the machine (not > forced by the program)" > > this is true, but you > have to tradeoff the setup time vs production > t
Electronics Forum | Sat Jan 08 00:47:12 EST 2005 | Grant
Hi, Yes, one of the problems with the MYDATA is the feeders are in groups, but at the same time, they are simple, and don't break. But the new Agillis 12 and 16 mm feeders do jam a bit. It's worse on glued cover tape, while heat bonded cover tape is
Electronics Forum | Tue Jul 10 11:36:22 EDT 2007 | dyoungquist
Hi SMT Frog We are using an upgraded Mydata TP9-1 system to place 0402s. We do an electrical test plus mechanical centering and use the C14 tool. A few things we have observed/learned: 1) Is the machine not picking the part up out of the tape? Po
Electronics Forum | Thu Mar 15 18:15:28 EDT 2018 | maustin
The 740 has been a great machine for us. We've been able to reliably load components as small as 0603 (we've not tried 0402, but I believe with a special nozzle adaptor, you can get it to work) and place a 7x7 56 pin QFN with 0.4mm pin pitch with hi