Electronics Forum | Thu Oct 29 16:22:42 EDT 2020 | spoiltforchoice
The software is crazy expensive for some of this stuff and in many cases you could develop the bits of it you actually use in-house for a fraction of the cost. Unless you are a company who really like this level of process control and you run multip
Electronics Forum | Mon Jul 26 03:32:31 EDT 1999 | Jason
| | | Hello, | | | i'm looking for informations about companies which are using system to verify the loadind of a SMT machine by using barcode (on the slot on the machine & on the reel). | | | I'm in charge of the installation of this kind of system
Electronics Forum | Thu Mar 22 12:46:43 EDT 2007 | Hussman
Those Panasonic machines should be able to tell ya pick-up rates form the feeders and shape code errors (components it doesn't recognize). You will probably get a more pick-up errors than anything else. Most of this is due to plastic tape versus pa
Electronics Forum | Wed Sep 17 11:13:06 EDT 2008 | daxman
You had mentioned that your volumes will be low? How about the mix? will you be changing over to different products a lot? How many different products will you be running? Will feeder setups be done by the operators or will you have a another departm
Electronics Forum | Thu Mar 10 21:21:54 EST 2011 | thatguy
I have 7yrs experience with JUKI's and I liked 2000 series(2050,2060) dont get caught up in the 730 or 760 these machines are obsolete or at least on there way and spare parts are hard to come buy. The 2060 is the chip shooter. I like the user friend
Electronics Forum | Sat Jun 27 00:23:26 EDT 2009 | grantp
Hi, This is easy. If your just doing prototypes, then you could get by with a syringe of solder paste and a hear gun. You can put down a little solder paste on each page and then place the passives and heat gun the board. If you have other active p
Electronics Forum | Thu Jan 13 09:00:42 EST 2005 | fasst1
Grant, Again, just my .02 worth. I would have to agree with Greg as well. Two Flex machines from the same vendor will give you much better line balancing, and I think better overall capability than adding a different type of 'animal' chip shooter
Electronics Forum | Sat May 22 19:02:04 EDT 2004 | Grant
Hi, I had another thread on this, however it's kind of petered out, and so I thought I would start another more specific thread. We have been looking at both the Fuji CP7 and the Universal HSP4797 however really have no idea what to choose. It seem
Electronics Forum | Thu Jan 04 15:39:07 EST 2007 | dyoungquist
While the 85% yield on a per board basis seems low, we are actually running over 99% yield on a per solder joint basis as there are about 17,700 joints per panel. On average, 9 out of 63 boards in the panel need rework. Rework issues include missin
Electronics Forum | Thu Sep 17 10:39:36 EDT 1998 | Jim Gustin
| We are a small contract assembly shop hand placing SMT. We recently received a large contract for SMD that will require placement rates of at least 6,000 CPH. I am looking at Fuji, Mydata, Quad, and Zevatech. I have little experience with automated