Electronics Forum | Tue Jun 07 12:07:30 EDT 2016 | wlsmt
Sorry davef. I was not being clear. PCBAs came out cold soldered after being reflowed the first time with ALPHA WS-820. The flux gel ALPHA WS 609 was supposed to be applied only onto the terminations of caps where ALPHA WS-820 was for a second refl
Electronics Forum | Mon Jun 06 12:51:17 EDT 2016 | wlsmt
My operator applied flux gel ALPHA WS-609 on MG P/N FTH101XAP (CAP ALUM 100UF 50V 20% SMD) before aqueous washing the PCBAs. Solder paste used was ALPHA WS-820. Now the caps have yellow stains. Any solution to this is appreciated. Tks
Electronics Forum | Sun Aug 13 00:15:58 EDT 2017 | deanm
We manufacture low volume, high reliability assemblies (class 3) that are conformal coated. Up until now we have been cleaning after SMT, then after through hole, then immediately prior to coating with test, formal inspection, etc. between cleaning p
Electronics Forum | Mon Jan 18 12:59:29 EST 2010 | deanm
Looking to find out what materials are commonly used for staking (aka. bonding) through hole components to the PCB in order to withstand vibration in a military (class 3) environment. Polyurethane coating would be applied after staking. I've found st
Electronics Forum | Wed Jun 15 10:38:41 EDT 2016 | laynefelix
Hi everyone..i am new here. I am hardware design engineer and as per my experience PCBAs came out cold soldered after being reflowed the first time with ALPHA WS-820. The flux gel ALPHA WS 609 was supposed to be applied only onto the terminations of
Electronics Forum | Mon Aug 19 13:54:47 EDT 2019 | emeto
Totally use them in production cycle - dispose after use. Some companies think that you should keep them in your pocket for months. Now they become way dirtier than people's hands. Other than that they work good ...I have seen worker's fingerprints o
Electronics Forum | Fri Apr 03 02:52:42 EST 1998 | Jacqueline Coia
At this moment in time we are using water soluble solder paste on our PCBs these are cleaned using water only, agitated with ultrasonics. After drying a white/grey residue is left around solder joints. Reflow profile is fine and a reliable wash proce
Electronics Forum | Fri Sep 06 16:24:36 EDT 2019 | linux
We use similar switch and the same oven. You need to modify the stencil, increase surface area. Have modified all our stencils to the point where we no longer use inline glue dispensers for any product
Electronics Forum | Tue Dec 26 10:54:37 EST 2006 | yusufgomec
We use hot air leveling (HAL) process in pcb production. HAL process is 3 steps. �n 1. step flux. 2. step is HAL. And 3. step is rinsing. As you know there is mustn't any flux after rinsing operation. Our flux chemical is water soluable. But there ar
Electronics Forum | Fri Apr 09 09:08:40 EDT 2010 | cast2010
Hello, I produce two types of board. - 100% Thru Hole - 50% thru hole and 50% SMT For the second, I have a bad wetting after the reflow on the top. The pcb board have Au-Ni pad. I use a water soluble paste. I clean the board with a solution with
winsouce.jpg)
