Electronics Forum | Mon Sep 26 08:39:39 EDT 2005 | avalancher
Not that this actually happens anymore, but could it possibly be moisture in the PCB? Have you tried baking one or two for a couple of hours then run to see if it repeats?
Electronics Forum | Mon Jan 08 19:52:14 EST 2007 | fastek
A soft limit error is an error due to trying to drive the head outside it's mechanical limits. Check your X-axis program data for this part.
Electronics Forum | Mon Aug 06 18:58:12 EDT 2007 | edruppert
This message indicates that the Peak to Peak voltage for the x axis motor encoder is too low. Possible cable/encoder or MOT1 board problem. Machine will either exhibit this during intialization or while running. Diagnostics in service routine may he
Electronics Forum | Thu Jul 24 11:02:29 EDT 2008 | markhoch
Try swapping the MOT card. Just be sure not to swap with the X-Axis card.
Electronics Forum | Wed Jun 27 14:36:22 EDT 2012 | cyber_wolf
If the X axis is moving then maybe your Elmo is not adjusted correctly. There is a procedure to adjust it in the manual(assuming you have the original manual). The correct location is XGTS which is a white connector on the booster. The fans are 24V
Electronics Forum | Sun Aug 04 19:42:50 EDT 2013 | starlogixs
Thanks for the reply Sarason. The software looks interesting, as we are a small manufacturer. However I do need the original Juki software for a calibration file. The X axis motor has been replaced but the calibration file is missing to teach and ca
Electronics Forum | Fri Mar 17 12:00:52 EDT 2023 | previnmoore
Its the kiss 103 selective solder machine. The end of the travel, it's the x axis. when i tried jogging it nothing happens just makes a noise. Thanks for responding.
Electronics Forum | Mon Sep 09 10:15:29 EDT 2019 | oxygensmd
Hello Everybody, I have a Siplace S20 machine which make X axis counting error. I replaced the sensor, scale and all the parts are good. It seems to be measuring error because the machine do measing error if the X axe move to much. Do somebody have
Electronics Forum | Sun Sep 25 11:18:16 EDT 2005 | CS
Hi! I'm facing a strange problem where PCB expanded in X & Y-axis after bottom-side reflow. When the PCB send for Top-side printing process, it is abvious that the printing alignment on the PCB's pads are out. With the problem mentioned above, I am
Electronics Forum | Fri Aug 11 17:21:43 EDT 2000 | Dave F
John: Sorry I'm tardy getting back to you on this Heat capacity = [applied voltage in volts*applied current in amps*(time ending in seconds - time start in seconds)]/(�K ending - �K start) The units of heat capacity are joules per mole-degree when