Electronics Forum | Mon Apr 08 15:39:10 EDT 2024 | mistrthou
The error is: MOT-Command/205: Motor speed out of control Motor speed deviates from expected speed. – Problem with power supply, motor current too low. – Mechanical problem, friction too high or tool stuck in Z. I'd be looking at excessive friction
Electronics Forum | Mon Feb 06 19:01:44 EST 2023 | nitroone
We are looking for support for the Cheetah evo, Its giving a low voltage error.
Electronics Forum | Thu Apr 28 01:30:54 EDT 2022 | sophyluo1985
Achieving high reliability and high efficiency in SMT process (Surface Mount Technology) assembly has always been the goal of electronics manufacturers expecting consistency. It depends on the optimization of every detail of the whole process. For SM
Electronics Forum | Fri Apr 08 09:32:09 EDT 2005 | bystrom123
We are using a low end Air vac system to place the BGA's. We have X ray we can use. Our CGA's as well use this system. They are one off parts that are above the 20K a piece range. So I have been tasked with making sure all of these procedures are the
Electronics Forum | Thu Aug 19 23:56:49 EDT 1999 | Earl Moon
| | I'm trying a second time to post this very important message, to me, concerning Air-Vac's following creation. Does any own and use this stuff successfully to remove solder from 20 layer and up MLB's with .020" diameter holes? Also, is any of the
Electronics Forum | Sun Apr 25 04:12:34 EDT 1999 | Earl Moon
| At Sanders (Military manufacturer), we have only started using plastic parts within the past few years. After being tasked with reviewing the new J-Std-033, it became obvious to me our process for controlling device exposure is weak. We build very
Electronics Forum | Sun Aug 15 05:45:15 EDT 1999 | Brian
Boca, Dave Sorry, but I cannot let this go. I'll go along with you that, at the time that the Montreal Protocol was initially signed (September 1987), there was no scientific proof that CFCs etc. were causing ozone depletion. There was, however, ve
1 |