Electronics Forum | Wed Jan 05 09:24:53 EST 2005 | cyber_wolf
Well...here is what I can tell you: I have over $40K worth of bent A12,A13,A14 tools.Yes you heard me right $40K worth. (Since 1995) Mydata used to make a repair kit to fix them but decided to quit. They tell me the reason they quit making the kit i
Electronics Forum | Wed Jan 05 10:55:12 EST 2005 | OverTheHill
WOW Sr.Tech, 40K worth of bent tools? I'm about ready to be sh*t canned because of 1K's worth. As for trimming the mags, the product is running fine (many boards) and then out of nowhere the tool bends, so I assume my PERFECT operators trimmed the ma
Electronics Forum | Tue Jun 26 15:05:02 EDT 2012 | upguy
Thanks for responding Fred and Peter. We have had the same damage to the tip occur even though our TP9-UFP sits in an air conditioned room (74 F / 23 C). I spoke with Matt at MyData (who was very helpful). He said that the X-axis bearings, the X-a
Electronics Forum | Wed Jul 18 06:47:38 EDT 2007 | cyber_wolf
I was asking if it was a TP9 2U...... If you have a UFP machine then you are in luck. It is most likely the small X-motor. You can test it in the service program. Does the X-axis bounce when you are trimming magazines and stepping through placement
Electronics Forum | Wed Jun 27 11:58:42 EDT 2012 | cyber_wolf
Your tool tips are being damaged because the small x-motor is not engaging when the head is picking parts. When this happens the head overshoots and you bang the tips on the mag springs. Directly after a tip gets damaged go into the service program a
Electronics Forum | Tue Jul 17 12:57:41 EDT 2007 | cyber_wolf
Is your machine a TP9 2U ? If you have a UFP or a MY series machine this condition usually points towards a bad X-wagon motor.
Electronics Forum | Wed Jul 18 07:48:12 EDT 2007 | cyber_wolf
Bad small X motor most likely. Other possibilities: Bad cables Bad Card
Electronics Forum | Thu Jul 19 06:49:38 EDT 2007 | cyber_wolf
Chris, Are you sure about the joystick trackball statement? He said he is seing "bounce" when he steps through placements and when he trims mag positions. That would indicate a issue with the small x-mot system to me.
Electronics Forum | Thu Jul 19 06:57:15 EDT 2007 | cyber_wolf
Peter, GO TEST YOUR SMALL X-MOTOR IN THE SERVICE PROGRAM !!!!!! Do not start changing parameter files ! I assume that your machine worked fine at one time with the original parameter file.
Electronics Forum | Thu Jul 19 08:33:37 EDT 2007 | allgood
Ok I can get into the service program - under Motors there is only a single X motor listed. And what test can you do - seems that I can only display ranges and settings? No test as such?