Electronics Forum | Tue Jul 14 13:20:13 EDT 2020 | tomdegas
I have a MY12 running TPS 2.8.1 and I need to know how to calibrate the X wagon Visin system. The machine is off in the Y direction after I removed and replaced the camera.
Electronics Forum | Tue Jun 14 15:59:25 EDT 2022 | mikevb
Thanks! I just needed a response like that. I will do all that, and if it's still an issue, I'll change the x wagon encoder right? There are three encoders on the x wagon though? The white one on the x carriage, the white one on the x belt drive mo
Electronics Forum | Mon Apr 06 17:08:30 EDT 2020 | tima
Try swapping XWB board that is on top of X-Wagon. Have you try that? All signals go thru there. Another thing can be those 2 ribbon cables that are behind of X-Wagon. How long ago did you change them? What I would do is to move X to different positio
Electronics Forum | Wed Apr 05 10:53:52 EDT 2017 | prdmm1
we have the x wagon one and the one at the far right only.
Electronics Forum | Mon Jun 28 17:17:23 EDT 2021 | SMTA-64387687
The 2 big ribbon cables, on top of the X wagon. They run from the booster board, in the back, to the board on top of the X-wagon. They wear out and need to be replaced, periodically. Since, the tool cycle works, the Z-motion is probably working ok. I
Electronics Forum | Tue Sep 08 09:37:55 EDT 2009 | cyber_wolf
We are seeing intermittent X-transducer errors. I notice that the X-wagon has more resistance over the Y-wagon area when I manually push it back and fourth. I am thinking the belt might need replaced. Has anyone else seen this before.
Electronics Forum | Fri Nov 22 00:09:29 EST 2019 | mk15
I am looking for some help for where to look to fix this MY15E problem. 1. after hardware initiation appear - F-MOT-MOVE X/250: Motor speed out of control (photo1). 2. in service mode when x motor initiate appear - F-MOT-MSETDYN X/12: No axis movemen
Electronics Forum | Tue Nov 15 08:17:05 EST 2005 | cyber_wolf
What are you trying to calibrate? I think you mis-typed...there is no W-wagon. I think you meant X-wagon camera. I have never seen one of these go out of cal. Why do you think it needs calibrated ?
Electronics Forum | Fri Oct 28 10:58:26 EDT 2011 | emeto
Hi, 1. Lubricate X shafts or gears or whatever you have on the machine. 2. Clean X encoder 3. Change motor 4. Change card
Electronics Forum | Mon Nov 25 02:15:07 EST 2019 | mk15
it is possible to test x belt motor and x wagon motor.
