Electronics Forum | Thu May 14 12:29:39 EDT 2015 | christinapaz
Hi All, On occasion we see components that have gone through pick and place and are slightly misaligned. Currently, operators manually adjust these misaligned components to prevent reflow failures. However, I am wondering if this readjustment may be
Electronics Forum | Mon Apr 18 19:58:22 EDT 2022 | cbeneat
I had the same question. We have custom nozzles made by Count on Tools. I believe we found urethane works the best for the silicon domed LEDs. Have you slowed the feed rate down on the feeder? Also adjust the top tape to the back slot on the feeder.
Electronics Forum | Wed Feb 05 21:03:35 EST 2014 | padawanlinuxero
On top of the feeder should be a small cover thats adjustable you need to unscrewed a little and move it forward to the pick up area this should give you enough space to cover the other component another thing you can try is check if all the feeder
Electronics Forum | Thu Aug 19 09:38:24 EDT 2004 | russ
We use a locally made fixture that uses tooling pins and a mating block to place the connector onto/into. We then use a toggle clamp to push the connector onto the board. We had to make no adjustments to stencil for our application. Russ
Electronics Forum | Fri Jan 25 05:22:47 EST 2008 | dekiper
Hi, You could try other types without brass shim. It's also important to use a good tool that is adjusted properly. Contact me and I will help you with quality samples and instructions. http://www.dekitools.com // Per Gester
Electronics Forum | Sun Jul 08 21:56:19 EDT 2012 | jeffr
Send me your email address... I will send you the document. Please note that you need the Light Adjuster tool to do it !
Electronics Forum | Tue Nov 28 10:30:14 EST 2017 | georgetruitt
CHECK OUT INSULFAB OR STONE MOUNTAIN TOOL http://insulfabtools.com/gallery http://stonemountaintool.com/fixtures/
Electronics Forum | Mon Oct 18 18:17:50 EDT 2021 | cyber_wolf
I brought all the major players machines in house and tried them. VisiConsult was the best hands down. Extremely simple GUI..no adjusting to get correct counts. The counting cloud feature is also a very slick tool. Support is 5 star.
Electronics Forum | Mon Aug 14 05:45:16 EDT 2023 | dimamalin
First, this is the result of bad printer setup. Adjust knife pressure, PCB gap, separation speed, tooling, and stencil cleaning. Pay attention to the coating of contacts pad and height of solder mask of PCB.
Electronics Forum | Tue Dec 03 07:57:27 EST 2002 | pjc
Price of DEK 248 and MPM UP100 are about the same, $22-36K range. MPM UP100 has programmable squeegee pressure. Precise, repeatable results with less operator involvement. Pressure parameters saved in board program file. DEK 248 has manual microm
