Electronics Forum | Sun Sep 24 20:50:47 EDT 2006 | KEN
...another nice feature is editing your own post. I just found a spelling error (dooh) on a post. Smiley faces. We want smiley faces!
Electronics Forum | Tue Feb 12 12:47:02 EST 2019 | slthomas
Someone with some more definitive knowledge of these machines will no doubt chime in at some point, but my thought was that the "A-table" is just a data table that stores I/O information. Thus, being "off in A-table YV100X:N2323 YV100XT:n2223" just m
Electronics Forum | Thu Jul 30 08:46:12 EDT 2015 | hemantp
We are having X-Ray Machine X TEK HMXST-160 The machine is working fine with respect to Interlocking , X-ray on , but not able to zoom and move the Joystick positions ,it is stand only in one position while starting the application we are getting
Electronics Forum | Tue Apr 02 14:56:30 EDT 2024 | kingkelvin
Hi all - my problem is a bit worse now - I can get all hydra tests to pass in extended service, except indicator levels at current 7 a bit high past 190 limit at ~210-220 - other than that hydra bank re-installs OK - but still it makes a bad hitting
Electronics Forum | Mon Apr 08 15:47:07 EDT 2024 | kingkelvin
Hi all - all good info thanks, so my indicator levels are a bit off which I knew - but I didn't realize that might be the source of this problem - after speaking with PFI and realizing the next step is to get the indicator levels to the 190 range (ma
Electronics Forum | Thu Jul 30 10:59:05 EDT 2015 | emeto
Hi, I had similar problem on my Dage X-ray machine. I had to reinstall the firmware for the Nextmove card. Check your CDs you have with the machine and you should have a software(and manuals) which you will use to reinstall the firmware on your cont
Electronics Forum | Tue Feb 27 11:43:18 EST 2024 | erikfriesen
I think error 21 at the drive is encoder communication issues, but google may tell you more. It's probably going to be one of three things, either the encoder, the cable, or the drive. I don't recall, but is the encoder integrated on the motor? If yo
Electronics Forum | Fri Jan 12 11:04:09 EST 2007 | mika
zero > in manual Control > bring the head close to the end of the machine so that you can reach the head => Diagnostic meny > engage the clutches and THIS IS VERY IMPORTANT: use Extreme Caution (you can flip off the X-Y circuit braker on the lower ba
Electronics Forum | Wed Aug 16 12:57:14 EDT 2017 | dleeper
I would contact the manufacturer of your machine. X-Ray equipment isn't something you want to fool with if you don't know what your doing.
Electronics Forum | Thu Mar 21 15:31:16 EDT 2024 | carl_p
That's possible but the OP doesn't state that so it's a bit open as it could be something else.
