Electronics Forum | Fri Oct 22 16:05:34 EDT 2021 | Katie Marzocchi
VJ Electronix has some great counters and the pricing is competitive. There's great info and datasheets here. https://www.vjelectronix.com/smt-inventory-management-with-x-ray-component-counting/
Electronics Forum | Thu Jan 06 11:46:19 EST 2000 | Damian Oatway
Could anyone recommend any companies who manufacture counters for reeled components. Anyone who has any info on the accuracy and reliability of these systems and if there are any alternatives to the usual systems? Cheers.
Electronics Forum | Thu Jan 06 15:27:50 EST 2000 | Christopher Lampron
Damian, I have used the Schleuniger, Inc. CC-15 components counter. This is a hand crank operated instruments that counts the holes in the carrier tape. It is simple to operate and set up. We have found the accuracy to be upwards of 98% providing th
Electronics Forum | Fri Jan 07 10:35:34 EST 2000 | Bill Copperthwaite
Somehow the link did not show up. They are at www.vtekusa.com Regards, Bill
Electronics Forum | Fri Jan 07 10:32:21 EST 2000 | Bill Copperthwaite
I have used the PC-2500 from V-TEK and have encountered no problems. It has a motorised reel handling system and can handle various tape pitches and reel sizes.It has an accuracy in excess of 99%.Check out their website below. Billc
Electronics Forum | Mon Oct 18 18:17:50 EDT 2021 | cyber_wolf
I brought all the major players machines in house and tried them. VisiConsult was the best hands down. Extremely simple GUI..no adjusting to get correct counts. The counting cloud feature is also a very slick tool. Support is 5 star.
Electronics Forum | Mon Oct 18 14:31:01 EDT 2021 | charliedci
We recently purchased a Scienscope AXC-800 III which can count 4 7" reels at one time in seconds. It can count tubes, trays and bulk as long as keep the components down to 1 layer (which for bulk is not ideal). so far we are very happy with, cuts dai
Electronics Forum | Wed Oct 27 07:34:14 EDT 2021 | reinhardk
Hi, we have a DAGE Assure machine, and we are happy with the results it gives us. Even without proper teaching the results were good (for common part sizes). *With* proper teaching results are even better. Only in certain cases results are unusabl
Electronics Forum | Fri Jan 19 13:31:14 EST 2007 | lit51
Is the failure just out of tolerance or is it non functioning? For tolerance problem, compare the x-rays of the good and bad units. It will take a very high resolution x-ray to spot the differences. Changes in capacitance values can occur based on
Electronics Forum | Fri Oct 15 05:20:21 EDT 2021 | jandon
Does anyone have experience with DAGE Assure, Hawkeye 1000, XRHCount or similar X-ray component counters? I myself have no experience with any X-ray equipment so any kind of feedback is important.
.gif)
winsouce.jpg)