Electronics Forum | Wed Sep 10 14:44:27 EDT 2014 | cyber_wolf
The machine has a vacuum pump in it.
Electronics Forum | Wed Sep 10 07:47:47 EDT 2014 | fnorradd
We have just recently purchased a Dage X Ray machine and in transportation the vacuum tube has lost its vacuum. Other than Dage, does anyone know of a company who is capable of re vacuuming the tube to the correct pressure? Any assistance would be
Electronics Forum | Thu Sep 11 03:33:22 EDT 2014 | fnorradd
The machine has a vacuum pump in it. This is what I expected also, but the machine does not have a Vac pump on it. The unit is sealed by Dage, the unit is a crystal type vacuum tube not a filament type. Regards. Darron
Electronics Forum | Thu Sep 22 10:04:33 EDT 2022 | micropak
Good Morning, I have a Phoenix PCBA Analyzer 160KV with NanoFocus tube. The machine warms up till 104KV only (it gets some breakdowns around 100KV) and then it finishes warmup but doesn't go beyond 103KV while doing inspections. HTG Cable has been gr
Electronics Forum | Mon Nov 21 08:01:44 EST 2016 | edgard_franca
Hello everybody, The company that I work bought a second hand Phoenix X-Ray model PCBA 100. We installed the equipament and waited about 4 hours for warm the x-ray tube, after that time was generated the image. I turned off correctly the machine bu
Electronics Forum | Tue Jan 09 11:04:01 EST 2024 | micropak
Hi Anyone happen to have service manuals (level 1 & 2) for GE/Phoenix X-Ray ? Particularly looking for X-Ray tube service information.
Electronics Forum | Mon Jun 18 11:15:53 EDT 2001 | Gil Zweig
The cost of an x-ray inspection system will be determined by the following inter-related paramers: 1. The focal spot size of the x-ray source. 2. The maximum tube voltage. 3. The physical size and shielding requirements of the systems. 4. The design
Electronics Forum | Tue Jun 19 10:59:21 EDT 2001 | Gil Zweig
When x-ray inspecting BGA packages with metal heat spreaders tube voltages greater than those used for Plastic BGAs must be used. It must be recognized, however, that the tube votage required will depend on the particular sensitivity of the x-ray cam
Electronics Forum | Sat Jul 04 05:40:23 EDT 2015 | seshadri
Dear Distingushed Friends, I would like to gain some knowledge on X Ray. It is very Confusing for me to understand the difference between the DAGE Transmissive tube Vs YXLON micro focus tube. The Target power Vs Tube power and detailed detectabilit
Electronics Forum | Fri Jan 09 11:15:00 EST 2004 | jmr2
We have a X- ray machine, CXR2000 from CR technology and Am having difficulties in locating a this company. for service and spare parts If anyone has any ideas, it would be greatly appreciated
