Electronics Forum | Mon Apr 06 17:08:30 EDT 2020 | tima
Try swapping XWB board that is on top of X-Wagon. Have you try that? All signals go thru there. Another thing can be those 2 ribbon cables that are behind of X-Wagon. How long ago did you change them? What I would do is to move X to different positio
Electronics Forum | Mon Jun 28 17:17:23 EDT 2021 | SMTA-64387687
The 2 big ribbon cables, on top of the X wagon. They run from the booster board, in the back, to the board on top of the X-wagon. They wear out and need to be replaced, periodically. Since, the tool cycle works, the Z-motion is probably working ok. I
Electronics Forum | Tue Feb 28 08:19:03 EST 2012 | cyber_wolf
Replace both of the big X-wagon ribbon cables to start with. You always have to rule those out before looking at anything else.
Electronics Forum | Sun Nov 27 11:19:55 EST 2005 | cyber_wolf
Dude, Scope the big ribbon cables on either side of the X-axis for cracks. They usually break where the clamp holds them on the X wagon. Also, all of your X camera stuff goes through the XWB board.Try swapping it if you have another. I am not sure
Electronics Forum | Fri Mar 06 19:32:09 EST 2020 | SMTA-Alex
The fact, that your Hydra head goes up and then starts moving slowly, means that it didn't find the limit. Since there are no mechanical obstructions and you swapped all the boards, the things to look at are cabling. Double check the ribbon cables fo
Electronics Forum | Fri Mar 24 16:45:03 EDT 2023 | tey422
I believe I was working with the early MY12 model too. Yes, the X-wagon blue ribbon cable were showing wear and tear very fast. Another frequent break downs were the center-jaw, ribbon broke. Most of the Mydata repairs can be done inhouse with spar
Electronics Forum | Wed Apr 15 12:57:37 EDT 2009 | bk
I'm not sure if you fixed your problem yet or not but i'll give you some insight on your problem. The x wagon motor doesn't move cause of the voltage it actually moves when there's current applied to it. The voltage dictates the direction the motor m
Electronics Forum | Fri Aug 06 14:01:53 EDT 2021 | tomdegas
Unfortunately all my tools are spring loaded. Yes I do know the tool install utility. I have been running and maintaining the 3 MyData machines for over 20 years and I never saw an error like this. I grease our tools once a month so I know that is
Electronics Forum | Tue Apr 05 11:03:13 EDT 2005 | cyber_wolf
There are several things that can cause these errors. It sounds as if you have 2 problems. A (Z) problem and a theta problem. 1. Check that the Z-locks are functioning properly in the service program. Make sure that when they are un-locked they don'
Electronics Forum | Wed Jan 05 10:55:12 EST 2005 | OverTheHill
WOW Sr.Tech, 40K worth of bent tools? I'm about ready to be sh*t canned because of 1K's worth. As for trimming the mags, the product is running fine (many boards) and then out of nowhere the tool bends, so I assume my PERFECT operators trimmed the ma
.gif)
.gif)
