Electronics Forum | Tue Sep 18 13:21:06 EDT 2001 | fcouture
Hello Jeff, I found some good information from what I read until now...so thank you! I have two questions: 1) What finish did you use on the PCB for 0201 ? I think with an aperture so small (12x15mils) tin plated is impossible, what do you think
Electronics Forum | Mon Jan 09 17:35:32 EST 2006 | russ
How are people getting BGAs reworked on boards that are 15"x15" at .06" thick? The BGAs are pretty much in the center of these assemblies. We have just received these and I cannot keep from warping/bowing as much as 1/2" at the heated area. Our bot
Electronics Forum | Fri Sep 24 17:40:30 EDT 2010 | microman
Hello, We are looking at purchasing a Versatronics RV4S. I am looking for some impartial advice on it's capabilities. The majority of our boards will have 0603 passives and maybe one or two 100 pin TQFP's, however, we are expecting to go down to 040
Electronics Forum | Mon Nov 13 13:26:43 EST 2017 | rcooley4
Hi all, I'm in the market for a BGA rework machine capable of handling a wide range of PCB's, anything from little 2"X2" board up to 15"X15" back-plane boards that are 0.100" thick. I would like to find a machine that can remove BGA's & QFN's, clean
Electronics Forum | Fri Apr 27 13:04:35 EDT 2007 | rmitchell
Hi, I am having some problems with my Fuji CP6 placement repeatability. The placement drifts during the build about .06-.10 mm on parts. It has happened on several different builds this week. It is enough to cause some defects after reflow on smal
Electronics Forum | Fri Jul 14 11:34:37 EDT 2000 | Mike F
John, The first thing to check is how tight the boards are being held in the conveyor (assuming you are using a finger conveyor). They should be a little loose at the input end so there is some room to expand. If the boards are held too tightly, when
Electronics Forum | Wed Apr 14 20:39:02 EDT 1999 | Dave F
| I need to cure conformal coat on a 19" x 15" board. The material needs 7 - 10 minutes at 100deg C, but I have limited floorspace so I'm looking for an oven with about 36 inches heated length and 18 or more inch wide belt. The material we are consid
Electronics Forum | Sat Apr 17 11:56:04 EDT 1999 | Graham Naisbitt
Mike First, you MUST make sure the oven used is extracted. The coating will contain TDI. This is not nice. You would be better considering a silicone solventless. Try contacting HumiSeal. They had a material on the TAC line at Nepcon West that lo
Electronics Forum | Wed Mar 04 21:24:04 EST 1998 | Ron Costa
Hello everyone! Does any know anything about bare board size variations? Is there a spec. or tolerance? I'm running small lots of boards and during the screen printing process I find that I cannot paste each board perfectly.I've tried other screen pr
Electronics Forum | Fri Mar 21 09:08:53 EST 2003 | mantis
Hi all, I have a strange problem,while building a large 15x15inch 3.5mm thick Pcb.During topside reflow i am experiencing some misaligned parts and even bridging on a bga that are sitting very close to a D size tantalum cap.The strange thing is that
