Electronics Forum | Fri Sep 24 17:40:30 EDT 2010 | microman
Hello, We are looking at purchasing a Versatronics RV4S. I am looking for some impartial advice on it's capabilities. The majority of our boards will have 0603 passives and maybe one or two 100 pin TQFP's, however, we are expecting to go down to 040
Electronics Forum | Mon Nov 13 13:26:43 EST 2017 | rcooley4
Hi all, I'm in the market for a BGA rework machine capable of handling a wide range of PCB's, anything from little 2"X2" board up to 15"X15" back-plane boards that are 0.100" thick. I would like to find a machine that can remove BGA's & QFN's, clean
Electronics Forum | Fri Apr 27 13:04:35 EDT 2007 | rmitchell
Hi, I am having some problems with my Fuji CP6 placement repeatability. The placement drifts during the build about .06-.10 mm on parts. It has happened on several different builds this week. It is enough to cause some defects after reflow on smal
Electronics Forum | Fri Jul 14 11:34:37 EDT 2000 | Mike F
John, The first thing to check is how tight the boards are being held in the conveyor (assuming you are using a finger conveyor). They should be a little loose at the input end so there is some room to expand. If the boards are held too tightly, when
Electronics Forum | Wed Apr 14 20:39:02 EDT 1999 | Dave F
| I need to cure conformal coat on a 19" x 15" board. The material needs 7 - 10 minutes at 100deg C, but I have limited floorspace so I'm looking for an oven with about 36 inches heated length and 18 or more inch wide belt. The material we are consid
Electronics Forum | Sat Apr 17 11:56:04 EDT 1999 | Graham Naisbitt
Mike First, you MUST make sure the oven used is extracted. The coating will contain TDI. This is not nice. You would be better considering a silicone solventless. Try contacting HumiSeal. They had a material on the TAC line at Nepcon West that lo
Electronics Forum | Wed Mar 04 21:24:04 EST 1998 | Ron Costa
Hello everyone! Does any know anything about bare board size variations? Is there a spec. or tolerance? I'm running small lots of boards and during the screen printing process I find that I cannot paste each board perfectly.I've tried other screen pr
Electronics Forum | Fri Mar 21 09:08:53 EST 2003 | mantis
Hi all, I have a strange problem,while building a large 15x15inch 3.5mm thick Pcb.During topside reflow i am experiencing some misaligned parts and even bridging on a bga that are sitting very close to a D size tantalum cap.The strange thing is that
Electronics Forum | Mon Dec 29 08:54:46 EST 2003 | pjc
SPM is superior. SPM has larger print area, up to 20� x 19", vs. 17.7� x 15.7� for the UltraPrint 100. UP100 is microprocessor controlled while the SPM has a PC. The SPM cameras can be positioned more rapidly and with greater accuracy than UP100's.
Electronics Forum | Fri Jun 04 21:27:16 EDT 2010 | deanm
We have a 4 zone Quad ZCR 531B reflow oven with top side heaters only and a mesh belt. Our boards are 2-6 layer, range in size from 2x2 to 7x15, 0402 to D2PAK. What are the limitations/drawbacks of having top side only heat, especially since about ha
.gif)
.jpg)
