Electronics Forum | Wed Mar 18 22:26:06 EST 1998 | Aaron C. Wedemeyer
Introducing flat rate pricing to SMT Solder Paste Stencil repair. 15 x 15 or smaller = $125 - Larger stencils will be repaired for only $150 + shipping and handling. Visit our site today for a free cost comparison - We will prepare an analysis sho
Electronics Forum | Wed Aug 15 17:30:43 EDT 2001 | peterson
Hello All, We have an MPM 2000 screen printer. My question is this: we are having a stencil made that has both top and bottom side on a single foil. Our Process people are unsure if the machine parameters will allow it. The board size is 19x15. Can i
Electronics Forum | Fri Oct 11 09:41:22 EDT 2013 | wooly1
Does anybody know of some place that can reball a VFBGA component that is 7mm x 7mm in actual size? I have several that need to be done if they can be. I have only been able to find places that go down to 15mm x 15mm in size. Any info would be awesom
Electronics Forum | Tue May 06 21:35:27 EDT 2014 | davef
Indium recommendations: 0201's: * Stencil Opening = 11mil x 16mil rectangle * Foot Print = 12mil x 15mil rectangle * Stencil Thickness = 5mils * Spacing = 9mils Note: The most common stencil being utilized, is the laser cut electropolished, and in so
Electronics Forum | Tue Apr 13 23:27:34 EDT 1999 | Mike Flori
I need to cure conformal coat on a 19" x 15" board. The material needs 7 - 10 minutes at 100deg C, but I have limited floorspace so I'm looking for an oven with about 36 inches heated length and 18 or more inch wide belt. The material we are consider
Electronics Forum | Wed Apr 14 17:13:08 EDT 1999 | Stephen Oltmann
| I need to cure conformal coat on a 19" x 15" board. The material needs 7 - 10 minutes at 100deg C, but I have limited floorspace so I'm looking for an oven with about 36 inches heated length and 18 or more inch wide belt. The material we are consid
Electronics Forum | Wed Apr 14 17:14:49 EDT 1999 | Stephen Oltmann
Check with BTU. They have dryers in the length you need. Good luck! | | I need to cure conformal coat on a 19" x 15" board. The material needs 7 - 10 minutes at 100deg C, but I have limited floorspace so I'm looking for an oven with about 36 inches
Electronics Forum | Thu Aug 16 19:56:38 EDT 2001 | davef
Awww, blank those fine tech support people at MPM. We know more than they do. Having said that, duh, umm er, please clarify the problem. * Are you concerned about paste squirting through the holes of the side 2 portion of the stencil when you are
Electronics Forum | Tue Sep 18 13:21:06 EDT 2001 | fcouture
Hello Jeff, I found some good information from what I read until now...so thank you! I have two questions: 1) What finish did you use on the PCB for 0201 ? I think with an aperture so small (12x15mils) tin plated is impossible, what do you think
Electronics Forum | Mon Jan 09 17:35:32 EST 2006 | russ
How are people getting BGAs reworked on boards that are 15"x15" at .06" thick? The BGAs are pretty much in the center of these assemblies. We have just received these and I cannot keep from warping/bowing as much as 1/2" at the heated area. Our bot