Electronics Forum | Mon Oct 10 15:24:15 EDT 2005 | zl3vlf
Hello to all! Our Fuji FIP-3 placement machine has come up with a servo alarm (X2-axis) whenever we try to run the machine. The manuals don't go into a lot of detail as to the cause of this problem, but there is plenty of information on what the X2
Electronics Forum | Thu Mar 07 03:32:32 EST 2013 | benreben
Hi, Can you move the X2 axis manually? if you move head manually(twice) can you see the pulse incremented in the servo menu in IP? with servo just have some parts can defects: -servo it self -servo board -encoder on head
Electronics Forum | Thu Mar 07 11:23:13 EST 2013 | orlando216
Yes I can move x2 axis, and check the world/zero with pulses, and it does not lose the pulses.
Electronics Forum | Tue Oct 11 08:54:18 EDT 2005 | jdengler
-Are you running a program that worked before or is it a new program? -Is there any reason to suspect that the proper has been edited between working and error condition? Jerry
Electronics Forum | Tue Oct 11 15:30:28 EDT 2005 | Dave
Hi Jerry, I thought the same so tried running other programs that are known to work on the IP-3 but still no joy. I shall try Alan's suggestion with cleaning the linear scale and see what happens. Thanks!
Electronics Forum | Mon Oct 10 22:56:13 EDT 2005 | Alan.
Dave, it could be that you have some dirt or grease on the linear scale for the X-axis. Try getting into the rubber shield with a soft brush or perhaps a spray. Threebond Super Cleaner 6602 is very good for this purpose as it cleans and dries w
Electronics Forum | Tue Oct 11 18:21:36 EDT 2005 | stepheniii
Does it do nozzle changes at a different speed than the programs? It's been a while since I worked on these beasts. I"m wondering if it can handle slow speeds but at full bore it can't handle it. Maybe try one part with everything set to slow speed
Electronics Forum | Mon Mar 04 13:48:53 EST 2013 | orlando216
Greetings to all, I have the following problem with an IP-3 from Fuji, At display is says: Cannot Move: X1 Axis Feeding aborted Servo Alarm X2 AXIS Servo Ove
Electronics Forum | Wed Oct 25 11:25:12 EDT 2017 | paddyronan
Hi all, I have a recent issue with an IP3 machine. The machine cycles through normal power up routine. Then the video monitor and VME card shit themselves down and after a couple of minutes the CPU board powers down. However this is intermittent. Wh
Electronics Forum | Thu Oct 13 14:09:44 EDT 2005 | rcanten
If there is no option to send the proper data to the MTU it sounds like your line editor is configured incorrectly. You will still be able to send programs and the such but like you said you would never notice it until you had to send the proper back
