Electronics Forum | Thu Jul 03 11:29:27 EDT 2014 | bobpan
oh....by reseat the cards....i mean the transport cards that are located in the top right side of the machine above gantry 2.
Electronics Forum | Tue Sep 20 13:37:00 EDT 2005 | jasont
We have x30 PPU's across x3 FCM Base 1's which are not working properly (error is "image too low"??). Please advise on how to repair/replace these (besides Assembleon themselves). Thanks in advance, Jason
Electronics Forum | Thu Apr 28 03:58:52 EDT 2022 | erici
We are having problems with our Siemens Siplace S27 machine. The machine is giving the error - Y-axis Faulty initialization of Motor. We replaced the Y motor card and swapped also the servo control cards on the two gantries. Still will not initiali
Electronics Forum | Fri Dec 19 17:11:24 EST 2014 | guts1872
My QSP2 motors keep shutting off with an error message on the screen that says Z1 motion fail. Z safe motion motion failed due to previous error. When homing the heads I observe the servo amp indicator LEDs. They are all green while the gantries are
Electronics Forum | Fri Mar 29 16:57:07 EDT 2013 | aemery
Gentlemen, Just became a member and scanning the old posts hoping to help people out with their MPM printers. Most of this info is correct, the last post was the best. Offsets on an Accuflex printer can be put in either per process program or glob
Electronics Forum | Wed Nov 06 12:58:56 EST 2013 | bobpan
The key to figuring out mirae machine failures 'most of the time' is found in mr-terminal. Is this message from mr-terminal or is this the windows/program software error. Mirae 1010 machines have boot failure problems often. Sometimes if the z positi
Electronics Forum | Thu Jul 03 09:27:10 EDT 2014 | torch
Hey guys wonder if anyone can help me, having an issue with our Quad QSP2, at the moment it is displaying Tep2 - Send Status command failed Tep1 - Send Status command failed and there is no response from the gantries, the interlocks appear to be wo
Electronics Forum | Mon Jan 28 13:40:53 EST 2019 | liquidspacie
Hello, I'm trying to fix this error and what I've done so far I cleaned (no scratches) measuring scale and swapped cards (gantry 1 & 2) and cleaned scale reader sensor. There are no spare parts, I'm just trding to narrow down the cause. Any suggestio
Electronics Forum | Fri Jun 26 06:32:33 EDT 2020 | dltechltd
Dear Victor, We have figured out what caused the error: One of it's MVS ICOS card had parity error (The MC reported that error too as seen in the previous pictures). We could see RED LED Light on the card, and we have pulled out, and checked: PAR_ER
Electronics Forum | Fri Sep 06 13:49:17 EDT 2002 | soupatech
Question: I am going to start placing 3mm x 3mm plastic smt leds and want the absolute lowest errors caused by the nozzle either dropping or allowing the part to shift. Would a 2.5mm nozzle be too big for the 3mm part. My logic is that the more surfa
