Electronics Forum | Wed Jan 23 14:26:52 EST 2008 | operator
I have seen the bad alignment error many times and never had to replace the head for it. It usually has something to do with the laser windows being dirty or cracked. Also it could be your profile settings. Make sure all of these things are perfect b
Electronics Forum | Wed Jan 23 12:35:24 EST 2008 | bobpan
Here is a few things to try.... 1. Spin the z-shaft with your fingers and make sure it is smooth and easy to turn. 2. Check your handling in your profile for the part that the software is locking up on.......You cannot go any slower than 40% or this
Electronics Forum | Fri Dec 14 19:56:40 EST 2018 | denisss
Good afternoon, the problem gives an error vision gantry x, an error occurs after the camera approaches the car wash and hits the piston, what could be the matter? are there any real specialists gives an error after a certain working time of 40 minut
Electronics Forum | Wed Apr 20 03:34:13 EDT 2022 | sophyluo1985
In the past we have solved problems like this for my clients, You can send me an email and tell me your problem and our engineering team will know how to deal with it.sales07@goldlandsmt.com
Electronics Forum | Mon Apr 18 18:23:41 EDT 2022 | youngbuck
Hello everyone, We have a Siemens HS50 error going on as soon as we boot up. It shows message saying "Machine is in test mode." Cause: Initalizing gantry axes. Start Sitest and check machine (firmwre versions,configuration, etc. It will try to refere
Electronics Forum | Tue Nov 13 04:47:19 EST 2018 | dhammika
hi Siplace Hs-60 defected due to below error Error- • Machine error:2271 Can bus: reception call aborted with time out seg:0 DEV: head 2 #:1 (this is not only head 2 ,error raise with all head interm
Electronics Forum | Mon Feb 02 11:51:54 EST 2004 | jsk
error code: motor comms failure.card3, Axis123 fatal error-reinitialize machine I swapped x3 and x4, and still get the same error. Any suggestion would be greatly appreciated Thanks in advance, jsk
Electronics Forum | Tue Oct 20 08:58:27 EDT 2009 | soudomphong
m/c error 3564 raceway monitoring triggered-gantry 3. In the help menu it says topic does not existed. Anybody has any idea what this error code mean? This is siemens hs60.
Electronics Forum | Thu Jul 03 11:29:27 EDT 2014 | bobpan
oh....by reseat the cards....i mean the transport cards that are located in the top right side of the machine above gantry 2.
Electronics Forum | Tue Sep 20 13:37:00 EDT 2005 | jasont
We have x30 PPU's across x3 FCM Base 1's which are not working properly (error is "image too low"??). Please advise on how to repair/replace these (besides Assembleon themselves). Thanks in advance, Jason