Electronics Forum | Thu Mar 14 15:26:34 EDT 2024 | gregoryyork
Hi After a little help we are based in England and have a Dage XD6500 Xray which has thrown up a really strange fault which our normal Dage service guy cant find. It says tube error and the error code is a 56 Volts fault from the Tube and cannot star
Electronics Forum | Fri Jul 07 17:17:43 EDT 2023 | ttheis
We swapped the Y1 and Y2 pc800 controllers with no change. We swapped out the UIMC III-I cards from another machine with no change. VRM amps all look OK, no errors. The machine moves the head both in the x and y directions during the zeroing attemp
Electronics Forum | Mon Feb 27 22:04:24 EST 2023 | kumarb
Hi. Our X4 is posting the attached error code. In the reference menu, the table dances to align with the SMD stencil and the shuttled PCB. During this activity, hearing some new mechanical ticking sounds that were not hear before. Any suggestions on
Electronics Forum | Sat Feb 21 21:25:59 EST 2004 | Ken
Check out Technomatix Unicam quality system. Uses bar code and computer terminal.
Electronics Forum | Fri Sep 29 11:08:41 EDT 2023 | carl_p
I'm not familiar with that machine type but I would assume on the board that is flashing with the fuse fault? Could you not try swopping the boards from the other machine to prove it as the board, do you not have the manual you can check the fault
Electronics Forum | Mon Feb 02 11:51:54 EST 2004 | jsk
error code: motor comms failure.card3, Axis123 fatal error-reinitialize machine I swapped x3 and x4, and still get the same error. Any suggestion would be greatly appreciated Thanks in advance, jsk
Electronics Forum | Tue Jul 30 01:56:49 EDT 2024 | hostlace
Check the machine's display or control panel for any particular fault codes or warnings. These can help you understand the exact nature of the soft parameter mistake. Consult the machine's user handbook or technical literature. The handbook frequentl
Electronics Forum | Thu Mar 15 17:50:18 EDT 2018 | sarason
Possibly a loose grub screw on one of the shafts controlling rotation or the sensor ot gray code wheel on the rotation servo motor. or even a small fault in the program eprom, Good luck sarason
Electronics Forum | Sun Feb 22 15:53:13 EST 2004 | Dreamsniper
Hi, Try using or creating a simple data collection system using MS Access...Try this idea: operator inspects the board, then scans the PCB barcode. Then enters the fault found using the codes you are using in your sheet. It's a bit laborious but it
Electronics Forum | Thu Feb 25 17:34:21 EST 2021 | roblackey
I think you are going to struggle without a laser designed for PCBAs (Asys, XJ Link etc) as they are designed to just burn into the resist and give good defininition, then readback to know you have a good mark. Key tips for our experience: Datama
.gif)
winsouce.jpg)