Electronics Forum | Tue Jan 24 08:01:32 EST 2012 | wolverine
When using the rectangular plate given with the machine that is used with calibrating the movable camera, does the longer side of the plate get fed into the machine ( rails set to 80mm ) or the shorter side ( rails set to 74mm ) Thanks Dave
Electronics Forum | Wed Jun 19 10:11:59 EDT 2019 | jamesn
Hi to everyone I hope someone can help me with a problem I have on a Quad QSP-2. when calibrating ( Or trying to use ) Feeder Bases 2 and 4 on gantry 2 Im getting small amounts of accumulative drift in the X axis. I have changed the servo amplifier
Electronics Forum | Fri Feb 19 11:13:02 EST 2016 | ttheis
I'm setting up a product for the first time on my GSM after I completed debugging some other issues. The previous owners had the PWC axis disabled and the axis motor disconnected, so I re-connected it and enabled it and now it homes and moves. When I
Electronics Forum | Thu Feb 21 06:18:42 EST 2013 | cbeneat
We run 3 Vitronics XPM2's, our newest is 3 years, oldest is 6+ and I have not seen our rails warp the way you're describing. I would be plenty frustrated if I had to replace rails this often.
Electronics Forum | Wed Sep 19 10:23:38 EDT 2012 | cbeneat
We Have 3 Vitronics XPM2's. I know nothing about any other manufacturer, but Vitronics has been extremely reliable. 2 Shifts 5 days a week for 6 years, and have never replaced a blower. Have had to change a few overtemp switches, and have had a fe
Electronics Forum | Mon Dec 14 12:59:36 EST 2015 | cbeneat
We have 5 XPM2's-XPM3I's, All 10 zone. Our oldest being 9+ years old and our newest being 8 months. All have been very reliable, PM maintenance is not complicated but can be time consuming. I have nothing to compare it to as my only experience is
Electronics Forum | Wed Aug 31 14:32:12 EDT 2011 | cbeneat
We run 3 XPM2's. All were new so under warranty, but I've found the support to be excellent over the years. They have moved their operation to MO recently, time will tell if this is an issue. The only maintenance issue I've run into is on our oldest
Electronics Forum | Wed Feb 23 20:48:14 EST 2022 | dekhead
MAINTENANCE, DIAGNOSTICS, RAIL SYSTEM, BELT SPEED CALIBRATION
Electronics Forum | Fri Jul 21 13:13:53 EDT 2006 | vikkaraja
I have checked the lead screw and guide rails. There is't any apparent damaged to any one of them. I was hoping it be the guide rails because they are much eaier to repalce than the lead screw. If I start messing around the lead screw, It would requi
Electronics Forum | Tue Nov 15 16:57:22 EST 2005 | bk
If your problem is happening part way through the calibration the problem might be there is too much friction from your Y-wagon. Measure the friction on the Y-wagon using the service program if it fails or if it is near the max allowed try oiling up
