Electronics Forum | Wed Sep 04 20:29:56 EDT 2013 | saibot
We had that problem a few months ago with one of ours. Had to replace both y-axis motors and the tech said it's a common problem with the Opal-XII.
Electronics Forum | Wed Sep 04 11:37:30 EDT 2013 | trice1212
Afternoon SMTnet forum users, The Assembleon Opal-XII we use has been showing an error when ran at 100% speed. We talked to the tech in AZ and he believes we have a problem with our y-motors. We turned the speed down and haven't had the problem com
Electronics Forum | Tue Mar 02 17:41:04 EST 2021 | astarotf
The heads in the middle of production stop and this error appears. We already checked the readers, linear encoders and changed the UIMC cards and found no errors, apparently all these revised parts are working. Can anyone help us where else can we c
Electronics Forum | Wed Mar 03 14:25:02 EST 2021 | astarotf
Hi Spoiltforchoice Thanks for the comment. With the line encoder readers that the machine brings, we performed a positioning reading check, which showed us the increase or decrease in the path that the heads make, with which we conclude that it is re
Electronics Forum | Wed Mar 03 10:14:45 EST 2021 | spoiltforchoice
I don't have one of these machines, but what kind of checks are you able to do on the linear encoders? On our Essemtec there is a dedicated diagnostic utility that gives you a plot of the encoder readout showing both the raw readout as a sort of roun
Electronics Forum | Fri Dec 10 02:49:06 EST 2010 | bagindia
we are facing vision error problem after running the machine for half an hour.Cause is x-axis motor % is changing & also motion is little harder compared with Y-axis
Electronics Forum | Wed Oct 26 05:44:39 EDT 2022 | spacecase
Hello all, I was looking at a Samsung SM421-f component placing machine and it's throwing up an error that was not described in the troubleshooting guide. Anytime I try to move the camera or home it the machine stops and the screen says that a skew e
Electronics Forum | Wed Oct 26 11:54:31 EDT 2022 | proceng1
To me, it sounds like your axis servo is losing steps. Can you get through the calibration steps? Hanwha is who we use for service. I'd say call them if you don't want to just throw parts at it.
Electronics Forum | Wed Oct 26 22:31:48 EDT 2022 | sarason
Broken wire connecting to the encoder on your servo, or anyware else in the feedback loop?, bent up encoder? sarason
Electronics Forum | Wed Oct 26 22:32:26 EDT 2022 | sarason
Broken wire connecting to the encoder on your servo, or anyware else in the feedback loop?, bent up encoder? sarason
